Home › Code lookup › P0247
Powertrain code · Fuel and air

P0247 Turbocharger/Supercharger Wastegate Solenoid "B"

How urgent? Get it checked in the next few days

What it means

The wastegate solenoid helps control how much boost the turbo makes. The computer sees a problem in this solenoid's circuit.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the solenoid connector, wiring and vacuum hoses
  2. Check the solenoid's resistance and command it with a scan tool

Signs you may notice

  • Check engine light on
  • Low power or limp mode
  • Boost may surge or feel too strong at times

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty wastegate (boost control) solenoid
  • CommonDamaged wiring or corroded connector
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new wastegate control solenoid or a wiring or hose repair.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P0247 mean?

The wastegate solenoid helps control how much boost the turbo makes. The computer sees a problem in this solenoid's circuit.

Can I drive with code P0247?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0247?

Common possibilities to test include: faulty wastegate (boost control) solenoid; damaged wiring or corroded connector; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.