Home › Code lookup › P024F
Powertrain code · Fuel and air

P024F Charge Air Cooler Bypass Position Sensor "A" Circuit High

How urgent? Book a check when convenient

What it means

A position sensor tells the computer where the intercooler bypass valve is sitting. The sensor's signal voltage is higher than it should ever be.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector and wiring
  2. Check the sensor's reference voltage, ground and signal with a meter

Signs you may notice

  • Check engine light on
  • Often no noticeable change in how it drives

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty bypass position sensor (often part of the valve assembly)
  • CommonDamaged wiring or corroded connector
  • PossibleShort or open in the sensor reference or ground wire
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Usually a new bypass valve assembly with its sensor, or a wiring repair.

Common questions

What does P024F mean?

A position sensor tells the computer where the intercooler bypass valve is sitting. The sensor's signal voltage is higher than it should ever be.

Can I drive with code P024F?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P024F?

Common possibilities to test include: faulty bypass position sensor (often part of the valve assembly); damaged wiring or corroded connector; short or open in the sensor reference or ground wire; engine computer fault. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.