P0257 Injection Pump Fuel Metering Control "B" Range/Performance (Cam/Rotor/Injector)
What it means
On diesel engines, this system controls how much fuel the injection pump delivers. The amount of fuel being delivered doesn't match what the computer is asking for.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check fuel supply pressure and replace a dirty fuel filter
- Inspect the injection pump connector and wiring
- Watch commanded versus actual fuel quantity on a scan tool
Signs you may notice
- Hard starting or no start
- Low power, surging or stalling
- Extra smoke from the exhaust
- Check engine light on
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty fuel metering solenoid or injection pump electronics
- CommonDamaged wiring or corroded connector at the pump
- CommonLow fuel supply from a clogged filter, weak lift pump or air in the fuel
- PossibleWorn injection pump
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Often a fuel supply repair or a new injection pump. Confirm fuel supply is good before replacing the pump.
Common questions
What does P0257 mean?
On diesel engines, this system controls how much fuel the injection pump delivers. The amount of fuel being delivered doesn't match what the computer is asking for.
Can I drive with code P0257?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0257?
Common possibilities to test include: faulty fuel metering solenoid or injection pump electronics; damaged wiring or corroded connector at the pump; low fuel supply from a clogged filter, weak lift pump or air in the fuel; worn injection pump. A shop should confirm the cause before replacing parts.