Home › Code lookup › P0260
Powertrain code · Fuel and air

P0260 Injection Pump Fuel Metering Control "B" Intermittent (Cam/Rotor/Injector)

How urgent? Get it checked in the next few days

What it means

On diesel engines, this system controls how much fuel the injection pump delivers. The control signal keeps cutting in and out.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check fuel supply pressure and replace a dirty fuel filter
  2. Inspect the injection pump connector and wiring
  3. Check the control circuit's resistance and voltage with a meter

Signs you may notice

  • Hard starting or no start
  • Low power, surging or stalling
  • Extra smoke from the exhaust
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty fuel metering solenoid or injection pump electronics
  • CommonLoose connector or chafed wiring at the pump
  • PossibleLow fuel supply from a clogged filter, weak lift pump or air in the fuel
  • PossibleWorn injection pump
  • PossibleEngine computer fault

Typical repair once the cause is confirmed

Often a fuel supply repair or a new injection pump. Confirm fuel supply is good before replacing the pump.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P0260 mean?

On diesel engines, this system controls how much fuel the injection pump delivers. The control signal keeps cutting in and out.

Can I drive with code P0260?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0260?

Common possibilities to test include: faulty fuel metering solenoid or injection pump electronics; loose connector or chafed wiring at the pump; low fuel supply from a clogged filter, weak lift pump or air in the fuel; worn injection pump. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.