Home › Code lookup › P0267
Powertrain code · Fuel and air

P0267 Cylinder 3 Injector Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees lower-than-expected voltage in the cylinder 3 fuel injector circuit. This usually points to a short to ground or a bad injector.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Measure the injector's resistance and compare it with the other injectors
  2. Inspect the injector wiring for rubbing or melted insulation

Signs you may notice

  • Check engine light on
  • Rough idle or shaking
  • Misfire, often with a cylinder 3 misfire code
  • Less power and worse fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonShorted coil in the cylinder 3 injector
  • CommonInjector wire shorted to ground
  • PossibleCorroded or damaged injector connector
  • PossibleFaulty injector driver in the engine computer

Typical repair once the cause is confirmed

Usually a new injector or a wiring repair.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0267 mean?

The computer sees lower-than-expected voltage in the cylinder 3 fuel injector circuit. This usually points to a short to ground or a bad injector.

Can I drive with code P0267?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0267?

Common possibilities to test include: shorted coil in the cylinder 3 injector; injector wire shorted to ground; corroded or damaged injector connector; faulty injector driver in the engine computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.