Home › Code lookup › P0274
Powertrain code · Fuel and air

P0274 Cylinder 5 Injector Circuit High

How urgent? Get it checked in the next few days

What it means

The computer sees higher-than-expected voltage in the cylinder 5 fuel injector circuit. This usually points to an unplugged or broken circuit, or a wire shorted to power.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the injector connector is fully plugged in and its pins are clean
  2. Measure the injector's resistance and check the wiring for breaks

Signs you may notice

  • Check engine light on
  • Rough idle or shaking
  • Misfire, often with a cylinder 5 misfire code
  • Less power and worse fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged or damaged injector connector
  • CommonOpen coil in the cylinder 5 injector
  • PossibleBroken injector wire
  • PossibleInjector wire shorted to power
  • PossibleFaulty injector driver in the engine computer

Typical repair once the cause is confirmed

Usually reconnecting or repairing the injector wiring, or a new injector.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0274 mean?

The computer sees higher-than-expected voltage in the cylinder 5 fuel injector circuit. This usually points to an unplugged or broken circuit, or a wire shorted to power.

Can I drive with code P0274?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0274?

Common possibilities to test include: unplugged or damaged injector connector; open coil in the cylinder 5 injector; broken injector wire; injector wire shorted to power. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.