Home › Code lookup › P0278
Powertrain code · Fuel and air

P0278 Cylinder 6 Contribution/Balance

How urgent? Get it checked in the next few days

What it means

The computer compares how much each cylinder helps spin the engine. Cylinder 6 is doing noticeably more or less work than the others.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Run a cylinder balance or contribution test with a scan tool
  2. Do a compression test on that cylinder
  3. Inspect the injector connector and wiring

Signs you may notice

  • Check engine light on
  • Rough idle, misfire or knocking
  • Extra smoke from the exhaust on diesels
  • Less power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWeak, leaking or clogged injector on cylinder 6
  • PossibleLow compression in that cylinder
  • PossibleInjector wiring or connector problem
  • PossibleIgnition problem on that cylinder (gas engines)

Typical repair once the cause is confirmed

Most often a new injector for that cylinder. A compression problem means deeper engine repair.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P0278 mean?

The computer compares how much each cylinder helps spin the engine. Cylinder 6 is doing noticeably more or less work than the others.

Can I drive with code P0278?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0278?

Common possibilities to test include: weak, leaking or clogged injector on cylinder 6; low compression in that cylinder; injector wiring or connector problem; ignition problem on that cylinder (gas engines). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.