Home › Code lookup › P029B
Powertrain code · Fuel and air

P029B Cylinder 1 - Fuel Trim at Min Limit

How urgent? Get it checked in the next few days

What it means

The computer is cutting as much fuel as it's allowed to on cylinder 1, and that cylinder still seems to run rich (too much fuel).

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other fuel trim, misfire or fuel pressure codes
  2. Have the cylinder 1 injector flow or balance tested

Signs you may notice

  • Check engine light on
  • Rough idle or misfire
  • Hard starting, fuel smell or black smoke

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLeaking or dripping cylinder 1 injector
  • PossibleInjector sticking partly open
  • PossibleFuel pressure too high
  • PossibleFaulty oxygen or air-fuel sensor reading

Typical repair once the cause is confirmed

Usually a new injector for that cylinder after fuel pressure is confirmed good.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P029B mean?

The computer is cutting as much fuel as it's allowed to on cylinder 1, and that cylinder still seems to run rich (too much fuel).

Can I drive with code P029B?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P029B?

Common possibilities to test include: leaking or dripping cylinder 1 injector; injector sticking partly open; fuel pressure too high; faulty oxygen or air-fuel sensor reading. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.