Home › Code lookup › P029E
Powertrain code · Fuel and air

P029E Cylinder 2 - Fuel Trim at Max Limit

How urgent? Get it checked in the next few days

What it means

The computer is adding as much fuel as it's allowed to on cylinder 2, and that cylinder still seems to run lean (short on fuel).

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check for other fuel trim, misfire or fuel pressure codes
  2. Have the cylinder 2 injector flow or balance tested

Signs you may notice

  • Check engine light on
  • Rough idle or misfire
  • Hesitation or less power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonClogged or restricted cylinder 2 injector
  • CommonVacuum leak near that cylinder's intake port
  • PossibleLow fuel pressure
  • PossibleInjector wiring or connector problem

Typical repair once the cause is confirmed

Usually cleaning or replacing the injector, or fixing a vacuum leak near that cylinder.

Walk through it step by step: Engine sputters or misfires →

Common questions

What does P029E mean?

The computer is adding as much fuel as it's allowed to on cylinder 2, and that cylinder still seems to run lean (short on fuel).

Can I drive with code P029E?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P029E?

Common possibilities to test include: clogged or restricted cylinder 2 injector; vacuum leak near that cylinder's intake port; low fuel pressure; injector wiring or connector problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.