Home › Code lookup › P0510
Powertrain code · Speed and idle control

P0510 Closed Throttle Position Switch

How urgent? Book a check when convenient

What it means

The switch that tells the computer the throttle is fully closed (foot off the gas) isn't reading correctly. Mostly found on older vehicles.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check that the throttle closes fully and smoothly
  2. Watch the closed throttle signal on a scan tool while opening and closing the throttle

Signs you may notice

  • Check engine light on
  • Unstable or high idle
  • Possible stalling when coming to a stop

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty or misadjusted closed throttle switch or throttle position sensor
  • CommonWiring or connector problem
  • PossibleSticking throttle linkage or dirty throttle body

Typical repair once the cause is confirmed

Usually a throttle position sensor or switch, or a throttle body cleaning.

Known on these vehicles

Walk through it step by step: Engine idles high →

Common questions

What does P0510 mean?

The switch that tells the computer the throttle is fully closed (foot off the gas) isn't reading correctly. Mostly found on older vehicles.

Can I drive with code P0510?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0510?

Common possibilities to test include: faulty or misadjusted closed throttle switch or throttle position sensor; wiring or connector problem; sticking throttle linkage or dirty throttle body. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.