Home › Code lookup › P051D
Powertrain code · Engine

P051D Crankcase Pressure Sensor Circuit High

How urgent? Book a check when convenient

What it means

The signal from the crankcase pressure sensor is higher than it should ever be, which usually points to a broken wire, bad ground or a failed sensor. This part monitors pressure inside the engine crankcase to check the PCV system.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and connector for broken wires or corrosion
  2. Check reference voltage and ground at the connector with a meter

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBroken wire or poor ground in the sensor circuit
  • CommonFaulty crankcase pressure sensor
  • PossibleUnplugged or corroded connector
  • PossibleSignal wire shorted to a voltage source

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new crankcase pressure sensor if it tests bad.

Common questions

What does P051D mean?

The signal from the crankcase pressure sensor is higher than it should ever be, which usually points to a broken wire, bad ground or a failed sensor. This part monitors pressure inside the engine crankcase to check the PCV system.

Can I drive with code P051D?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P051D?

Common possibilities to test include: broken wire or poor ground in the sensor circuit; faulty crankcase pressure sensor; unplugged or corroded connector; signal wire shorted to a voltage source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.