P0545 Exhaust Gas Temperature Sensor Circuit Low Bank 1 Sensor 1
What it means
The signal from the exhaust gas temperature sensor is lower than it should ever be, which usually points to a wiring short or a failed sensor. This part (bank 1, sensor 1) measures exhaust heat to protect the turbocharger, catalytic converter or particulate filter.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the wiring and connector for rubbing, damage or corrosion
- Check reference voltage and ground at the connector with a meter
Signs you may notice
- Check engine light on
- Possible reduced power on some diesel and turbo engines
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonSignal wire shorted to ground
- CommonFaulty exhaust gas temperature sensor
- PossibleCorroded or water-damaged connector
- PossibleProblem with the sensor's reference voltage supply
Typical repair once the cause is confirmed
Usually a wiring or connector repair, or a new exhaust gas temperature sensor if it tests bad.
Common questions
What does P0545 mean?
The signal from the exhaust gas temperature sensor is lower than it should ever be, which usually points to a wiring short or a failed sensor. This part (bank 1, sensor 1) measures exhaust heat to protect the turbocharger, catalytic converter or particulate filter.
Can I drive with code P0545?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0545?
Common possibilities to test include: signal wire shorted to ground; faulty exhaust gas temperature sensor; corroded or water-damaged connector; problem with the sensor's reference voltage supply. A shop should confirm the cause before replacing parts.