Home › Code lookup › P0548
Powertrain code · Emissions

P0548 Exhaust Gas Temperature Sensor Circuit Low Bank 2 Sensor 1

How urgent? Book a check when convenient

What it means

The signal from the exhaust gas temperature sensor is lower than it should ever be, which usually points to a wiring short or a failed sensor. This part (bank 2, sensor 1) measures exhaust heat to protect the turbocharger, catalytic converter or particulate filter.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and connector for rubbing, damage or corrosion
  2. Check reference voltage and ground at the connector with a meter

Signs you may notice

  • Check engine light on
  • Possible reduced power on some diesel and turbo engines

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSignal wire shorted to ground
  • CommonFaulty exhaust gas temperature sensor
  • PossibleCorroded or water-damaged connector
  • PossibleProblem with the sensor's reference voltage supply

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new exhaust gas temperature sensor if it tests bad.

Common questions

What does P0548 mean?

The signal from the exhaust gas temperature sensor is lower than it should ever be, which usually points to a wiring short or a failed sensor. This part (bank 2, sensor 1) measures exhaust heat to protect the turbocharger, catalytic converter or particulate filter.

Can I drive with code P0548?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0548?

Common possibilities to test include: signal wire shorted to ground; faulty exhaust gas temperature sensor; corroded or water-damaged connector; problem with the sensor's reference voltage supply. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.