P0551 Power Steering Pressure Sensor/Switch Circuit Range/Performance
What it means
The power steering pressure sensor is sending a reading that doesn't make sense or doesn't match other sensors. This part tells the computer when steering effort rises so it can bump the idle and avoid stalling.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the power steering pressure sensor reading on a scan tool with real conditions
- Check the power steering fluid level and look for leaks
- Inspect the wiring and connector for damage or corrosion
Signs you may notice
- Check engine light on
- Idle may dip or the engine may stall when turning the wheel at low speed
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty or sluggish power steering pressure sensor
- CommonLow power steering fluid or a weak power steering pump
- PossibleWiring or connector problem skewing the reading
- PossibleComputer fault (rare)
Typical repair once the cause is confirmed
Usually a new power steering pressure sensor or repair of the underlying problem, after ruling out wiring.
Common questions
What does P0551 mean?
The power steering pressure sensor is sending a reading that doesn't make sense or doesn't match other sensors. This part tells the computer when steering effort rises so it can bump the idle and avoid stalling.
Can I drive with code P0551?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0551?
Common possibilities to test include: faulty or sluggish power steering pressure sensor; low power steering fluid or a weak power steering pump; wiring or connector problem skewing the reading; computer fault (rare). A shop should confirm the cause before replacing parts.