Home › Code lookup › P0555
Powertrain code · Brakes

P0555 Brake Booster Pressure Sensor Circuit

How urgent? Get it checked in the next few days

What it means

The computer has spotted a problem in the wiring circuit for the brake booster pressure sensor. This part monitors vacuum in the brake booster that makes the brake pedal easy to push.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the brake booster pressure sensor wiring and connector for damage, corrosion or a loose fit
  2. Check related fuses and confirm power and ground at the sensor

Signs you may notice

  • Check engine light on
  • Brake pedal may feel harder if there is a real vacuum problem

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty brake booster pressure sensor
  • CommonDamaged wiring or a loose or corroded connector
  • PossibleBlown fuse or missing power or ground to the sensor
  • PossibleComputer fault (rare)

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new brake booster pressure sensor if it tests bad.

Walk through it step by step: Hard brake pedal →

Common questions

What does P0555 mean?

The computer has spotted a problem in the wiring circuit for the brake booster pressure sensor. This part monitors vacuum in the brake booster that makes the brake pedal easy to push.

Can I drive with code P0555?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0555?

Common possibilities to test include: faulty brake booster pressure sensor; damaged wiring or a loose or corroded connector; blown fuse or missing power or ground to the sensor; computer fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.