Home › Code lookup › P0558
Powertrain code · Brakes

P0558 Brake Booster Pressure Sensor Circuit High

How urgent? Get it checked in the next few days

What it means

The signal from the brake booster pressure sensor is higher than it should ever be, which usually points to a broken wire, bad ground or a failed sensor. This part monitors vacuum in the brake booster that makes the brake pedal easy to push.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the wiring and connector for broken wires or corrosion
  2. Check reference voltage and ground at the connector with a meter

Signs you may notice

  • Check engine light on
  • Brake pedal may feel harder if there is a real vacuum problem

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBroken wire or poor ground in the sensor circuit
  • CommonFaulty brake booster pressure sensor
  • PossibleUnplugged or corroded connector
  • PossibleSignal wire shorted to a voltage source

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new brake booster pressure sensor if it tests bad.

Walk through it step by step: Hard brake pedal →

Common questions

What does P0558 mean?

The signal from the brake booster pressure sensor is higher than it should ever be, which usually points to a broken wire, bad ground or a failed sensor. This part monitors vacuum in the brake booster that makes the brake pedal easy to push.

Can I drive with code P0558?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0558?

Common possibilities to test include: broken wire or poor ground in the sensor circuit; faulty brake booster pressure sensor; unplugged or corroded connector; signal wire shorted to a voltage source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.