P0562 System Voltage Low
What it means
The computer sees the vehicle's electrical voltage below normal, which usually points to the battery or charging system.
Can I keep driving?
Be careful: low voltage can mean the battery is draining as you drive, and the car may stall or not restart. If the battery light is on or lights dim, turn off extras and head straight to a shop. If the engine stumbles or steering gets heavy, pull over safely.
What to test before replacing parts
Load test the battery, check charging voltage at the battery, inspect cables, grounds and the drive belt, and check for a parasitic drain before replacing the alternator or battery.
- Test the battery and check that charging voltage is roughly 13.5 to 14.8 volts with the engine running
- Clean and tighten the battery terminals and grounds
- Inspect the serpentine belt and tensioner
- Check for other charging system codes
Signs you may notice
- Battery or charging warning light on
- Dim or flickering lights
- Slow cranking or no start
- Check engine light on
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWeak or failing battery
- CommonFailing alternator
- PossibleLoose or corroded battery cables or ground straps
- PossibleWorn or slipping serpentine belt
- PossibleHeavy drain from aftermarket accessories
Typical repair once the cause is confirmed
Most often a new alternator or battery, or a cable or ground repair.
Common questions
What does P0562 mean?
The computer sees the vehicle's electrical voltage below normal, which usually points to the battery or charging system.
Can I drive with code P0562?
Be careful: low voltage can mean the battery is draining as you drive, and the car may stall or not restart. If the battery light is on or lights dim, turn off extras and head straight to a shop. If the engine stumbles or steering gets heavy, pull over safely.
What causes P0562?
Common possibilities to test include: weak or failing battery; failing alternator; loose or corroded battery cables or ground straps; worn or slipping serpentine belt. A shop should confirm the cause before replacing parts.