Home › Code lookup › P0582
Powertrain code · Speed and idle control

P0582 Cruise Control Vacuum Control Circuit/Open

How urgent? Book a check when convenient

What it means

The computer found a problem, such as a broken connection, in the circuit it uses to control the cruise control vacuum solenoid. This part lets engine vacuum into the cruise servo on older vacuum-operated cruise systems.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the cruise control vacuum solenoid wiring and connector for damage or corrosion
  2. Check related fuses and relays
  3. Test the cruise control vacuum solenoid with a meter or scan tool and compare with spec

Signs you may notice

  • Cruise control not working
  • Check engine light on

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFaulty cruise control vacuum solenoid
  • CommonBroken wire or loose or corroded connector
  • PossibleBlown fuse or failed relay
  • PossibleComputer driver circuit fault (rare)

Typical repair once the cause is confirmed

Usually a wiring or connector repair, or a new cruise control vacuum solenoid if it tests bad.

Common questions

What does P0582 mean?

The computer found a problem, such as a broken connection, in the circuit it uses to control the cruise control vacuum solenoid. This part lets engine vacuum into the cruise servo on older vacuum-operated cruise systems.

Can I drive with code P0582?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0582?

Common possibilities to test include: faulty cruise control vacuum solenoid; broken wire or loose or corroded connector; blown fuse or failed relay; computer driver circuit fault (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.