P0597 Thermostat Heater Control Circuit/Open
What it means
The computer found a problem, such as a broken connection, in the circuit it uses to control the thermostat heater. This part warms an electronic thermostat so the computer can open it early and keep the engine cooler under load.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the thermostat heater wiring and connector for damage or corrosion
- Check related fuses and relays
- Test the thermostat heater with a meter or scan tool and compare with spec
Signs you may notice
- Check engine light on
- Engine may run hotter than normal under load
- Temperature gauge may read higher than usual
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty thermostat heater
- CommonBroken wire or loose or corroded connector
- PossibleBlown fuse or failed relay
- PossibleComputer driver circuit fault (rare)
Typical repair once the cause is confirmed
Usually a wiring or connector repair, or a new thermostat assembly, since the heater is built into it.
Common questions
What does P0597 mean?
The computer found a problem, such as a broken connection, in the circuit it uses to control the thermostat heater. This part warms an electronic thermostat so the computer can open it early and keep the engine cooler under load.
Can I drive with code P0597?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0597?
Common possibilities to test include: faulty thermostat heater; broken wire or loose or corroded connector; blown fuse or failed relay; computer driver circuit fault (rare). A shop should confirm the cause before replacing parts.