Home › Code lookup › U0020
Network code · Network

U0020 Low Speed CAN Communication Bus Performance

How urgent? Get it checked in the next few days

What it means

Messages on the low speed CAN network, the network the car's computers use to talk to each other, are not getting through reliably.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging voltage
  2. Check network resistance at the diagnostic port (about 60 ohms on most high speed CAN networks)
  3. Unplug modules one at a time to find one shorting the network
  4. Inspect wiring in areas that see water, heat or movement

Signs you may notice

  • Several warning lights on at once
  • Some gauges or features may stop working
  • Car may not start in some cases

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonDamaged, chafed or corroded network wiring
  • CommonLoose or corroded connector at a module
  • CommonA failed module dragging the network down
  • PossibleWater getting into a connector
  • PossibleLow battery voltage

Typical repair once the cause is confirmed

Find and repair the damaged network wire or connector, or replace the module that is shorting the network.

Walk through it step by step: Many dashboard lights on at once →

Common questions

What does U0020 mean?

Messages on the low speed CAN network, the network the car's computers use to talk to each other, are not getting through reliably.

Can I drive with code U0020?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0020?

Common possibilities to test include: damaged, chafed or corroded network wiring; loose or corroded connector at a module; a failed module dragging the network down; water getting into a connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.