Home › Code lookup › U0074
Network code · Network

U0074 Control Module Communication Bus "B" Off

How urgent? Get it checked in the next few days

What it means

A control module shut itself off the network because of too many communication errors.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Test the battery and charging voltage
  2. Check network resistance at the diagnostic port (about 60 ohms on most high speed CAN networks)
  3. Unplug modules one at a time to find one shorting the network
  4. Inspect wiring in areas that see water, heat or movement

Signs you may notice

  • Several warning lights on at once
  • Some gauges or features may stop working
  • Car may not start in some cases

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonNetwork wiring short or open
  • CommonA failing module flooding the network
  • CommonLow battery voltage
  • PossibleModule that set the code is failing

Typical repair once the cause is confirmed

Find and repair the damaged network wire or connector, or replace the module that is shorting the network.

Walk through it step by step: Many dashboard lights on at once →

Common questions

What does U0074 mean?

A control module shut itself off the network because of too many communication errors.

Can I drive with code U0074?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0074?

Common possibilities to test include: network wiring short or open; a failing module flooding the network; low battery voltage; module that set the code is failing. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.