Home › Code lookup › U0328
Network code · Network

U0328 Software Incompatibility With Steering Angle Sensor Module

How urgent? Get it checked in the next few days

What it means

The software in the steering angle sensor module does not match what the other modules expect. This usually happens after a module was replaced, swapped from another vehicle or updated.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Ask whether any module was recently replaced or reprogrammed
  2. Check the module part number and software level against the maker data
  3. Keep a battery maintainer connected during any reprogramming

Signs you may notice

  • ABS, traction control or stability light on
  • ABS and stability control may be turned off
  • Normal braking usually still works

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonModule replaced with a used or wrong part number
  • CommonModule not programmed, or programmed with the wrong software
  • PossibleSoftware update interrupted, for example by low battery voltage
  • PossibleOther modules need updating to match

Typical repair once the cause is confirmed

Program the module with the correct software using dealer-level tools.

Walk through it step by step: ABS light on →

Common questions

What does U0328 mean?

The software in the steering angle sensor module does not match what the other modules expect. This usually happens after a module was replaced, swapped from another vehicle or updated.

Can I drive with code U0328?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes U0328?

Common possibilities to test include: module replaced with a used or wrong part number; module not programmed, or programmed with the wrong software; software update interrupted, for example by low battery voltage; other modules need updating to match. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.