Acura CLproblems, repair costs and recalls
Problems reported across 1997–2003. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
25 documented issues across all years, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- Slow or erratic shifts, a flashing D4 light with the check engine light, sudden downshifts to second gear at highway speed, slipping, or no drive at all.
- Why it happens
- The 5-speed automatic in the second-generation CL wears out early. Acura extended the transmission warranty to 7 years or 100,000 miles on 2001-2002 and some 2003 CLs, and failure is by far the most reported problem.
- What to do
- If the D4 light flashes or shifts get rough, change the fluid with genuine Honda/Acura ATF and get a diagnosis right away. A sudden downshift at speed is dangerous, so don't put this off. Most failed units need a rebuild or replacement.
Second gear can break from overheating (recall)
- What you'll notice
- Usually no warning before failure. In the worst case the transmission locks up while driving.
- Why it happens
- Heat builds up between two second-gear parts inside the automatic transmission, which can chip or break gear teeth.
- What to do
- Check your VIN for open recalls. The dealer adds a fluid line change on low-mileage cars, or inspects the gears and replaces the transmission if overheating damage is found.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Automatic transmission shifting problems and failure
- What you'll notice
- Harsh or delayed shifts, slipping, flaring revs between gears, or the car not moving in drive.
- Why it happens
- Automatic transmission complaints are among the most common for the first-generation CL, with some owners needing more than one transmission.
- What to do
- Check the fluid level and condition. If it slips or won't engage, stop driving hard and have the transmission diagnosed before more damage is done.
Driver airbag inflator can rupture (recall)
- What you'll notice
- No warning signs. You may have received a recall letter.
- Why it happens
- The original Takata driver airbag inflator, and some replacement inflators fitted later, can absorb moisture and rupture in a crash, throwing metal fragments.
- What to do
- Ask the dealer to confirm the recall applies to your VIN and get the free inflator replacement now, even if an earlier airbag recall was done.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Older driver airbag inflator can rupture (recall)
- What you'll notice
- No warning signs. You may have received a recall letter.
- Why it happens
- Driver airbag inflators used in 1996-2001 Honda and Acura models can absorb moisture over time, which can make them rupture or underinflate in a crash.
- What to do
- Look up your VIN and have the dealer inspect and replace the inflator for free.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Engine stalls from worn ignition switch (recall)
- What you'll notice
- The engine shuts off without warning while driving, or the car won't start; jiggling the key may bring power back.
- Why it happens
- Electrical contacts inside the ignition switch wear out and lose connection.
- What to do
- Check your VIN for an open recall and have the free ignition switch replacement done. If it stalls, steer to safety; steering and brakes get heavier with the engine off.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Key comes out when not in Park (recall)
- What you'll notice
- You can turn off the car and remove the key without the shifter being fully in Park, and the car may roll away.
- Why it happens
- Wear in the ignition key cylinder lets the shift interlock stop working.
- What to do
- Always set the parking brake. Check your VIN and have the dealer inspect and replace the worn interlock parts for free.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Front lower ball joints wear out (recall)
- What you'll notice
- Clunking from the front over bumps, loose steering, or uneven tire wear. In the worst case the joint separates and the front wheel collapses.
- Why it happens
- The front lower ball joints on these cars could wear out early.
- What to do
- Check your VIN for this recall, and have the ball joints inspected if you hear clunks. Do not drive a car with a loose ball joint.
Free if the recall was never done. If it was, worn joints later are a normal repair.
Car can roll while in Park (recall)
- What you'll notice
- The car moves or rolls down a slope even though the shifter is in Park.
- Why it happens
- A casting flaw in a transmission cover could stop the parking pawl from locking the transmission on some 1998 2.3CL automatics.
- What to do
- Use the parking brake every time you park. Check your VIN for the recall; dealers add a collar so the parking pawl engages properly.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Timing belt can break from misaligned pulley (recall)
- What you'll notice
- A squeal or ticking from the front of the engine, then the engine stalls and won't restart if the belt breaks.
- Why it happens
- On some 2003 V6 engines, a misaligned water pump pulley let the timing belt rub on a cylinder head bolt until it broke. This engine can suffer internal damage when the belt fails.
- What to do
- Check your VIN for this recall. Dealers inspect the water pump and replace it and the timing belt if needed.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Rusted front subframe on passenger side
- What you'll notice
- Clunks or creaks from the front, odd steering feel, or a failed inspection for rust. The subframe can rust through near the control arm mounts.
- Why it happens
- Owners report heavy subframe rust on the passenger side, which they link to air conditioner condensation dripping onto it, made worse by road salt.
- What to do
- Have the subframe inspected on a lift, especially in salt states. Badly rusted subframes need replacing, since a failure can affect steering.
Airbag (SRS) light on
- What you'll notice
- The SRS airbag warning light stays on or flickers.
- Why it happens
- Owners trace it to a faulty seat belt buckle switch, a failed SRS control module or wiring problems. While the light is on, airbags may not deploy.
- What to do
- Have the SRS codes read by a shop with the right scan tool. Fix it promptly, because the airbags may be disabled.
Worn engine mounts cause vibration
- What you'll notice
- Vibration through the seat and steering wheel at idle in gear or around highway speed, and a clunk when shifting or accelerating.
- Why it happens
- The rubber and fluid-filled engine mounts wear out with age. Owners report replacing front and side mounts.
- What to do
- Have the mounts checked. Replace broken mounts soon, because they let the engine move and strain hoses, axles and other mounts.
Cranks but won't start when hot
- What you'll notice
- On hot days or after a drive, the engine cranks but won't fire. After it cools down it usually starts again.
- Why it happens
- Owners have traced this to a failing fuel pump or fuel injection (main) relay that loses contact when warm, cutting power to the fuel pump.
- What to do
- When it happens, have a shop check for fuel pump power and spark. Replacing the relay is a cheap common fix.
Misfire from failed ignition coil
- What you'll notice
- Shaking at idle, a stumble when accelerating, and a flashing or steady check engine light.
- Why it happens
- One of the six individual ignition coils fails and stops firing its cylinder.
- What to do
- Have the misfire codes read to find the cylinder. Replace the bad coil and check the spark plugs; avoid hard driving with a flashing light, which can damage the catalytic converter.
Front axle failure or vibration
- What you'll notice
- Clicking when turning, vibration under acceleration, or an axle that breaks or pops out.
- Why it happens
- Owners report worn or rusted front CV axles, and broken axles on hard acceleration.
- What to do
- Have the axles and boots inspected if you hear clicking. Replace a worn axle before it breaks and leaves you stranded.
Starter fails to crank the engine
- What you'll notice
- A click or nothing at all when you turn the key, even though the lights work.
- Why it happens
- Starter and ignition parts are a common complaint on these cars. Corroded battery terminals can cause the same symptom.
- What to do
- Clean and tighten the battery terminals first. If it still won't crank, have the starter and ignition switch tested.
Power steering fluid leak and pump whine
- What you'll notice
- Whining from the engine bay when turning, especially when cold, and power steering fluid spots or low fluid.
- Why it happens
- Old O-rings and hoses in the power steering system leak or let air in. Using the wrong fluid also causes pump noise.
- What to do
- Check the fluid level and use only Honda power steering fluid. Replace leaking O-rings or hoses before the pump runs dry.
HID headlight flickering or going out
- What you'll notice
- One low-beam headlight flickers, changes color or goes dark.
- Why it happens
- The high-intensity discharge (HID) bulbs and their ballasts wear out with age.
- What to do
- Swap the bulbs side to side to see if the problem follows the bulb or stays with the ballast, then replace the faulty part. Replace bulbs in pairs so the color matches.
Brake vibration or noise from rusted rotors
- What you'll notice
- Pulsing in the brake pedal or steering wheel when stopping, grinding or scraping noise, or brakes that drag.
- Why it happens
- Rotors rust and wear unevenly, and caliper brackets can corrode.
- What to do
- Have the brakes inspected. New rotors and pads, plus cleaning or replacing corroded hardware, usually fixes it.
Auto-dimming mirror leaks dark fluid
- What you'll notice
- A black, tar-like fluid drips from the rearview mirror onto the console or seats, and the mirror may stop dimming.
- Why it happens
- The gel inside the self-dimming mirror leaks out as the mirror's seal fails.
- What to do
- Avoid touching the fluid with bare skin, clean it up, and replace the mirror.
Check engine light for EVAP leak
- What you'll notice
- The check engine light comes on but the car drives normally.
- Why it happens
- A worn fuel cap seal or a failed valve or sensor near the charcoal canister lets fuel vapor escape.
- What to do
- Replace the fuel cap first if its seal is cracked. If the light returns, have the EVAP system tested.
Check engine light from clogged EGR passages
- What you'll notice
- Check engine light with code P0401, sometimes with pinging or hesitation.
- Why it happens
- Carbon builds up in the EGR valve and intake passages until too little exhaust gas flows.
- What to do
- Have the EGR valve and passages cleaned and the gasket replaced. This is a common, moderate repair.
Driver power window stops working
- What you'll notice
- The driver window won't go up or down, or moves slowly.
- Why it happens
- The power window motor fails, sometimes more than once.
- What to do
- Have the motor and switch tested. Replacing the motor (and regulator if worn) fixes it.
Speedometer reads slower than actual speed
- What you'll notice
- The speedometer shows a lower speed than you are really going.
- Why it happens
- Owners report the speedometer reading slow; a failing speed sensor or gauge is the usual cause.
- What to do
- Check your speed with a phone GPS app and have the speed sensor and gauge tested. Wrong readings can lead to tickets.
Repair prices for your Acura CL
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission with remanufactured unit
- Replace automatic transmission with used or remanufactured unit
- Replace seat belt buckle switch or SRS control module
- Replace engine mounts
- No-start diagnosis and fuel injection (main) relay replacement
- Replace leaking power steering hose or O-rings and flush fluid
- Replace HID headlight bulb (one side)
- Replace ignition coil(s)
- Replace front CV axle/joint
- Front brake pads (rotors extra)
- Clean EGR passages and replace EGR valve
- Replace driver power window motor
- Replace vehicle speed sensor
- Replace starter
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Revise oil cooler line or replace transmissionNo charge if your vehicle is included
- Replace driver airbag inflatorNo charge if your vehicle is included
- Inspect and replace driver airbag inflatorNo charge if your vehicle is included
- Replace ignition switchNo charge if your vehicle is included
- Inspect and replace key cylinder interlock partsNo charge if your vehicle is included
- Replace front lower ball jointsNo charge if your vehicle is included
- Install collar on parking pawlNo charge if your vehicle is included
- Inspect/replace water pump and timing beltNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.