Your 2002 Acura CLproblems, repair costs and recalls
What we've documented about the 2002 Acura CL: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2002 Acura CL
12 documented issues apply to 2002, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- Slow or erratic shifts, a flashing D4 light with the check engine light, sudden downshifts to second gear at highway speed, slipping, or no drive at all.
- Why it happens
- The 5-speed automatic in the second-generation CL wears out early. Acura extended the transmission warranty to 7 years or 100,000 miles on 2001-2002 and some 2003 CLs, and failure is by far the most reported problem.
- What to do
- If the D4 light flashes or shifts get rough, change the fluid with genuine Honda/Acura ATF and get a diagnosis right away. A sudden downshift at speed is dangerous, so don't put this off. Most failed units need a rebuild or replacement.
Second gear can break from overheating (recall)
- What you'll notice
- Usually no warning before failure. In the worst case the transmission locks up while driving.
- Why it happens
- Heat builds up between two second-gear parts inside the automatic transmission, which can chip or break gear teeth.
- What to do
- Check your VIN for open recalls. The dealer adds a fluid line change on low-mileage cars, or inspects the gears and replaces the transmission if overheating damage is found.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Driver airbag inflator can rupture (recall)
- What you'll notice
- No warning signs. You may have received a recall letter.
- Why it happens
- The original Takata driver airbag inflator, and some replacement inflators fitted later, can absorb moisture and rupture in a crash, throwing metal fragments.
- What to do
- Ask the dealer to confirm the recall applies to your VIN and get the free inflator replacement now, even if an earlier airbag recall was done.
Free at the dealer under the recall. Ask the dealer to check your VIN for open recalls.
Rusted front subframe on passenger side
- What you'll notice
- Clunks or creaks from the front, odd steering feel, or a failed inspection for rust. The subframe can rust through near the control arm mounts.
- Why it happens
- Owners report heavy subframe rust on the passenger side, which they link to air conditioner condensation dripping onto it, made worse by road salt.
- What to do
- Have the subframe inspected on a lift, especially in salt states. Badly rusted subframes need replacing, since a failure can affect steering.
Airbag (SRS) light on
- What you'll notice
- The SRS airbag warning light stays on or flickers.
- Why it happens
- Owners trace it to a faulty seat belt buckle switch, a failed SRS control module or wiring problems. While the light is on, airbags may not deploy.
- What to do
- Have the SRS codes read by a shop with the right scan tool. Fix it promptly, because the airbags may be disabled.
Worn engine mounts cause vibration
- What you'll notice
- Vibration through the seat and steering wheel at idle in gear or around highway speed, and a clunk when shifting or accelerating.
- Why it happens
- The rubber and fluid-filled engine mounts wear out with age. Owners report replacing front and side mounts.
- What to do
- Have the mounts checked. Replace broken mounts soon, because they let the engine move and strain hoses, axles and other mounts.
Cranks but won't start when hot
- What you'll notice
- On hot days or after a drive, the engine cranks but won't fire. After it cools down it usually starts again.
- Why it happens
- Owners have traced this to a failing fuel pump or fuel injection (main) relay that loses contact when warm, cutting power to the fuel pump.
- What to do
- When it happens, have a shop check for fuel pump power and spark. Replacing the relay is a cheap common fix.
Misfire from failed ignition coil
- What you'll notice
- Shaking at idle, a stumble when accelerating, and a flashing or steady check engine light.
- Why it happens
- One of the six individual ignition coils fails and stops firing its cylinder.
- What to do
- Have the misfire codes read to find the cylinder. Replace the bad coil and check the spark plugs; avoid hard driving with a flashing light, which can damage the catalytic converter.
Front axle failure or vibration
- What you'll notice
- Clicking when turning, vibration under acceleration, or an axle that breaks or pops out.
- Why it happens
- Owners report worn or rusted front CV axles, and broken axles on hard acceleration.
- What to do
- Have the axles and boots inspected if you hear clicking. Replace a worn axle before it breaks and leaves you stranded.
Power steering fluid leak and pump whine
- What you'll notice
- Whining from the engine bay when turning, especially when cold, and power steering fluid spots or low fluid.
- Why it happens
- Old O-rings and hoses in the power steering system leak or let air in. Using the wrong fluid also causes pump noise.
- What to do
- Check the fluid level and use only Honda power steering fluid. Replace leaking O-rings or hoses before the pump runs dry.
HID headlight flickering or going out
- What you'll notice
- One low-beam headlight flickers, changes color or goes dark.
- Why it happens
- The high-intensity discharge (HID) bulbs and their ballasts wear out with age.
- What to do
- Swap the bulbs side to side to see if the problem follows the bulb or stays with the ballast, then replace the faulty part. Replace bulbs in pairs so the color matches.
Brake vibration or noise from rusted rotors
- What you'll notice
- Pulsing in the brake pedal or steering wheel when stopping, grinding or scraping noise, or brakes that drag.
- Why it happens
- Rotors rust and wear unevenly, and caliper brackets can corrode.
- What to do
- Have the brakes inspected. New rotors and pads, plus cleaning or replacing corroded hardware, usually fixes it.
Repair prices for your 2002 Acura CL
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission with remanufactured unit
- Replace seat belt buckle switch or SRS control module
- Replace engine mounts
- No-start diagnosis and fuel injection (main) relay replacement
- Replace leaking power steering hose or O-rings and flush fluid
- Replace HID headlight bulb (one side)
- Replace ignition coil(s)
- Replace front CV axle/joint
- Front brake pads (rotors extra)
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Revise oil cooler line or replace transmissionNo charge if your vehicle is included
- Replace driver airbag inflatorNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…