Your 2011 BMW 1 / 2 Seriesproblems, repair costs and recalls
What we've documented about the 2011 BMW 1 / 2 Series: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2011 BMW 1 / 2 Series
19 documented issues apply to 2011, most serious first.
Oil filter housing gasket leak
- What you'll notice
- Oil dripping under the front of the car, a burning oil smell, or oil coating the front of the engine and the drive belt area.
- Why it happens
- The rubber gasket under the oil filter housing hardens with age and heat and starts to leak. Oil can soak the serpentine belt, which may slip off and get pulled into the front of the engine.
- What to do
- Have it fixed soon rather than just topping up oil. A shredded belt can damage the engine, so do not drive far if the belt area is soaked in oil.
Electric water pump and thermostat failure
- What you'll notice
- An engine temperature warning, the radiator fan running at full speed, reduced power (limp mode), or a sudden overheat.
- Why it happens
- These engines use an electric coolant pump that tends to fail without warning, often around 60,000-80,000 miles. The thermostat often fails along with it.
- What to do
- Pull over and shut the engine off if it overheats. Have the pump and thermostat replaced together; many owners replace them before they fail on higher-mileage cars.
High-pressure fuel pump failure
- What you'll notice
- Long cranking before the engine starts, stuttering or power loss when accelerating, stalling, and a reduced-power warning.
- Why it happens
- The original high-pressure fuel pump on the N54 twin-turbo engine was not durable. BMW revised the pump and extended its coverage to 10 years or 120,000 miles.
- What to do
- Check whether the extended coverage still applies. If not, an updated pump fixes it; do not keep driving with severe hesitation.
Leaking fuel injectors cause misfires
- What you'll notice
- Misfires, a shaking engine, a flashing check engine light and loss of power.
- Why it happens
- The N54 piezo injectors fail or leak, and BMW went through many revisions of the part. Some cars had extended coverage on the injectors.
- What to do
- Have the misfiring cylinder identified. A leaking injector can wash oil off the cylinder walls, so fix it promptly and replace with the latest revision.
Driver airbag inflator can rupture (recalls)
- What you'll notice
- Usually no warning before a crash.
- Why it happens
- The driver frontal airbag inflator can build too much pressure and burst, throwing metal pieces into the cabin. Some interim replacement inflators were also recalled.
- What to do
- Check your VIN now and get the airbag replaced free at a BMW dealer.
Blower motor wiring can overheat and start a fire (recall)
- What you'll notice
- A burning plastic smell from the dash or heater fan, or the fan stopping working, even with the car parked.
- Why it happens
- The wiring harness for the blower motor regulator can overheat and melt its connector.
- What to do
- Check your VIN. Dealers inspect and replace the harness for free; until then, report any burning smell right away.
Battery cable connection can fail and cut power (recall)
- What you'll notice
- Sudden loss of electrical power, warning lights, stalling or a no-start.
- Why it happens
- The positive battery cable connector at the fuse box can degrade and lose contact.
- What to do
- Run a recall check. Dealers replace the connector and secure it with an improved design for free.
PCV valve heater can short and catch fire (recall)
- What you'll notice
- Possible burning smell from the engine bay; often no warning.
- Why it happens
- The heater for the crankcase vent (PCV) valve can short circuit and overheat, with a fire risk even when the car is off.
- What to do
- Check your VIN; cars repaired under the earlier recalls must go back for the newer fix.
VANOS housing bolts can loosen and stall the engine (recalls)
- What you'll notice
- Rattling from the engine, loss of power, a check engine light, or a stall.
- Why it happens
- The aluminum bolts holding the VANOS (cam timing) unit can loosen and snap.
- What to do
- Check your VIN for both recalls. Dealers replace the bolts for free.
Rear driveshaft joint can break (recall)
- What you'll notice
- Clunking or vibration from under the car, and in the worst case a sudden loss of drive.
- Why it happens
- The CV joint on the rear driveshaft of the 135i and 1 Series M can wear out and break.
- What to do
- Check your VIN; dealers inspect and replace the joint free.
Seat belt pretensioner can ignite insulation (recall)
- What you'll notice
- No warning until a crash.
- Why it happens
- When the front belt pretensioners fire in a serious crash, nearby sound insulation could catch fire.
- What to do
- Check your VIN; dealers replace the retractors and/or modify the insulation for free.
Valve cover gasket leak or cracked valve cover
- What you'll notice
- A burning oil smell (sometimes through the vents), light smoke from the engine bay, oil on the spark plugs, or a low oil warning.
- Why it happens
- The plastic valve cover can warp and crack and its rubber gasket hardens with heat cycles, letting oil seep onto the hot exhaust side of the engine.
- What to do
- Have a shop confirm the leak. Oil reaching the exhaust or turbo is a fire risk, so do not leave it for long.
Coolant leaks from plastic hoses and expansion tank
- What you'll notice
- A low coolant warning, a sweet smell, coolant drips, or overheating and limp mode in bad cases.
- Why it happens
- Many cooling-system parts are plastic and become brittle with age, so hoses, flanges, the coolant level sensor and the expansion tank start to leak. RepairPal lists coolant-related overheating as the most reported 228i problem.
- What to do
- Top up with BMW-approved coolant and have the system pressure-tested. Fix leaks early, because overheating can warp the cylinder head.
VANOS solenoid faults
- What you'll notice
- Check engine light, rough idle, hesitation or loss of power, poorer fuel economy, and sometimes reduced-power mode.
- Why it happens
- The VANOS solenoids that control variable cam timing wear or clog and stop controlling oil flow properly, typically from about 70,000-100,000 miles.
- What to do
- Have the codes read. Cleaning or replacing the solenoids is usually all that is needed, not a full VANOS rebuild.
Turbo wastegate rattle
- What you'll notice
- A metallic rattle from the engine when you lift off the throttle, a boost-related code (30FF), and eventually low power.
- Why it happens
- The wastegate arms in the N54 turbos loosen with wear. BMW issued extended coverage of 8 years or 82,000 miles for this rattle.
- What to do
- A light rattle is not urgent, but have it checked if you lose power. The fix is replacing the turbos, which is a big job.
Charge pipe cracks and loses boost
- What you'll notice
- A loud pop followed by power loss, no boost, and engine or drivetrain warning lights.
- Why it happens
- The plastic pipe between the turbo and the throttle becomes brittle with heat and age and can split, especially on tuned cars.
- What to do
- The car will usually limp along with low power. Replace the pipe, ideally with a stronger aftermarket aluminum one.
Carbon buildup on intake valves
- What you'll notice
- Rough idle, hesitation, misfires under load, lower power and fuel economy.
- Why it happens
- With direct injection, fuel never washes the intake valves, so carbon deposits build up over time, often noticeable after about 40,000-60,000 miles.
- What to do
- Ask a shop to inspect the intake valves. Walnut-shell blasting cleans them and restores smooth running.
Misfires and rough idle from worn coils or plugs
- What you'll notice
- Rough idle, misfires, slow starts in cold weather and a lack of power, sometimes without a VANOS code.
- Why it happens
- Spark plugs and ignition coils wear out; turbo engines are harder on them. Coils fail at higher mileage.
- What to do
- Have the misfire codes read. Replace worn plugs and any failing coils; plugs on turbo engines need changing more often than on non-turbo engines.
Window regulator failure
- What you'll notice
- A window that drops into the door, moves slowly or crookedly, or will not go up, often with a grinding noise.
- Why it happens
- The cables or plastic parts in the window regulator wear and break.
- What to do
- Avoid using the window until fixed. Replace the regulator (and the motor if it is also failing).
Repair prices for your 2011 BMW 1 / 2 Series
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace oil filter housing gasket (housing if cracked) and inspect drive belt
- Replace valve cover and gasket
- Replace electric water pump and thermostat
- Replace leaking coolant hose or expansion tank and bleed system
- Replace VANOS solenoids
- Replace high-pressure fuel pump
- Replace fuel injector(s) with latest revision
- Replace turbochargers
- Replace charge pipe
- Walnut-shell blast intake valves
- Replace spark plugs and failed ignition coils
- Replace window regulator
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Dealer recall repairNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…