Your 2008 Chrysler 300problems, repair costs and recalls
What we've documented about the 2008 Chrysler 300: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2008 Chrysler 300
3 documented issues apply to 2008, most serious first.
Oil sludge and internal coolant leak can ruin the engine (2.7L)
- What you'll notice
- Oil pressure light, ticking or knocking, running hot, milky or thick oil, and in bad cases sudden engine seizure.
- Why it happens
- The 2.7L V6 runs hot and is prone to sludge, linked to its crankcase ventilation and small oil capacity. Its water pump is driven by the timing chain inside the engine, so when its gasket fails coolant leaks into the oil. Owners and class-action suits reported complete engine failures.
- What to do
- Change oil on time with the correct oil. If the oil light comes on, you hear knocking, or the oil looks milky, stop driving and have the engine checked right away.
Worn front tension struts, ball joints and tie rods
- What you'll notice
- Clunking or banging over bumps, shaking over expansion joints, pulling to one side, alignment that will not stay set, and uneven tire wear.
- Why it happens
- The front suspension wears its tension strut (compression arm) bushings and ball joints early, and owners also report tie rod ends and struts needing replacement.
- What to do
- Have the front suspension inspected and the worn parts replaced, then get an alignment. Replace a loose ball joint or tension strut promptly because it affects steering control.
Broken exhaust manifold bolts (HEMI)
- What you'll notice
- A ticking sound, loudest on a cold start, that may fade as the engine warms up. You may smell exhaust under the hood or in the cabin.
- Why it happens
- Repeated heating and cooling makes the manifold flex until the bolts, usually at the rear of the head, snap. Exhaust then leaks past the gasket. It is often mistaken for lifter tick.
- What to do
- Have the manifold bolts inspected. Get the leak fixed soon if you smell exhaust inside the car.
Repair prices for your 2008 Chrysler 300
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Extract broken manifold bolts, replace bolts and gasket
- Replace engine with a used or remanufactured 2.7L
- Replace front tension struts and align
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…