Your 2005 Chrysler Pacificaproblems, repair costs and recalls
What we've documented about the 2005 Chrysler Pacifica: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2005 Chrysler Pacifica
9 documented issues apply to 2005, most serious first.
Engine cradle (subframe) rusting through
- What you'll notice
- Clunks from under the front of the vehicle, an engine that seems to shift, or a shop pointing out heavy rust or holes in the front subframe during an oil change or inspection. Some vans fail state safety inspection because of it.
- Why it happens
- The front subframe that carries the engine and front suspension was not given enough rust-proof coating at the factory. In salted-road areas it can rot through, and in bad cases the engine and suspension mounting points lose their strength.
- What to do
- Have the subframe inspected on a lift, especially on 2004-2005 vans from snowy states. If there are holes or flaking metal at the mounts, stop using the van for long trips until the cradle is replaced.
Engine stalls while driving
- What you'll notice
- The engine cuts out while driving or at a stop, sometimes with the dash lights flickering first. It often restarts, and dealers frequently find no stored code.
- Why it happens
- Owners and shops have traced it to several causes: a corroded engine ground wire (the G103 ground bolted to the engine), a sticking EGR valve, a failing TIPM, or a weak crank sensor.
- What to do
- Note when it happens and whether any lights flicker. Ask the shop to check the engine ground connections and the EGR valve first, since those are cheap fixes.
Automatic transmission limp mode, slipping or shudder
- What you'll notice
- The van gets stuck in one gear (limp mode), won't shift into 4th, slips, or shudders and vibrates at 30-40 mph.
- Why it happens
- The four-speed automatic in these vans can suffer from solenoid pack faults, leaking solenoid gaskets and a worn torque converter. A burst cooler hose can also drain the fluid.
- What to do
- Check the fluid level and look for leaks. Have the codes read; a solenoid pack or torque converter repair costs much less than a full transmission if caught early.
Halogen headlights can cut out (recall)
- What you'll notice
- One or both headlights flicker or go out while driving, at first now and then and later for good.
- Why it happens
- On some 2005 vans with halogen headlamps, a fault in the headlamp circuit can make the low beams stop working.
- What to do
- Check the VIN for recall 05V066 and have it done for free. Avoid night driving if the headlights flicker.
Done free by a Chrysler dealer under recall 05V-066.
Fuel pump module and engine software can stall the engine (recall)
- What you'll notice
- The engine dies while driving with no warning, sometimes after the fuel level runs low.
- Why it happens
- Under some conditions the fuel pump module and the engine computer software can combine to starve the engine and stall it.
- What to do
- Check the VIN for recall 06V432. The dealer updates the software and fuel pump parts for free.
Done free by a Chrysler dealer under recall 06V-432.
Front-end clunks from tie rods, sway bar links and control arm bushings
- What you'll notice
- Clunking or rattling over bumps, loose or wandering steering, uneven tire wear, or a knock when you start moving.
- Why it happens
- Tie rod ends, sway bar links and bushings, and front lower control arm bushings on this heavy crossover wear quickly. Early 2004s had especially weak control arm bushings, and some owners replaced tie rods more than once.
- What to do
- Have the front end inspected. Sway bar links are cheap; worn tie rods need prompt replacement and a wheel alignment because a broken one causes loss of steering.
Engine mounts tearing or leaking
- What you'll notice
- A heavy clunk when shifting into drive or reverse or when you step on the gas, more vibration at idle, and an engine that visibly rocks.
- Why it happens
- The fluid-filled engine mounts on the Pacifica tear and leak, and owners report replacing them more than once.
- What to do
- Have the mounts checked with the engine running and in gear. Replace broken mounts soon, because a loose engine strains hoses, wiring, ground straps and the transmission.
EGR valve sticking, rough idle and check engine light
- What you'll notice
- Check engine light (often code P0401 or P0404), rough or stumbling idle, hesitation, or stalling when coming to a stop.
- Why it happens
- The electrically driven exhaust gas recirculation (EGR) valve gets clogged with carbon and stops opening or closing correctly.
- What to do
- Have the codes read. Cleaning or replacing the EGR valve is usually an inexpensive fix that also cures some stalling complaints.
Radiator cracks and coolant leaks
- What you'll notice
- Coolant puddles under the front, a sweet smell, the temperature gauge rising, or the low coolant warning.
- Why it happens
- The plastic radiator tanks crack with age and heat cycles. Radiators and coolant hoses are among the most-replaced parts reported by Pacifica owners.
- What to do
- Top up with the correct coolant and have the system pressure-tested. Don't keep driving if it overheats.
Repair prices for your 2005 Chrysler Pacifica
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front engine cradle (subframe) and align
- Diagnose stalling; repair engine ground or replace EGR valve
- Replace solenoid pack or torque converter; replace transmission if worn out
- Replace worn tie rod ends and sway bar links, then align
- Replace engine mount(s)
- Replace EGR valve
- Replace radiator and refill coolant
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Repair headlamp circuit (free recall repair)No charge if your vehicle is included
- Update engine software and fuel pump module (free recall repair)No charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…