Your 2006 Dodge Magnumproblems, repair costs and recalls
What we've documented about the 2006 Dodge Magnum: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2006 Dodge Magnum
13 documented issues apply to 2006, most serious first.
Oil sludge or coolant in the oil ruins the engine (2.7L)
- What you'll notice
- Knocking or ticking that gets worse, an oil pressure light, milky or very dark thick oil, coolant that keeps going down with no outside leak, and eventually an engine that seizes or won't restart.
- Why it happens
- The 2.7L V6 runs hot and holds little oil, so it is prone to sludge, especially when oil changes are stretched. Its water pump sits behind the timing chain, and when the pump's seal or gasket leaks, coolant goes straight into the oil and destroys the bearings.
- What to do
- Change the oil on time with the correct synthetic and watch the coolant level closely. If coolant drops with no visible leak or the oil looks milky, stop driving and have the water pump checked right away. If the engine is already knocking, get a second opinion before paying for repairs, since replacement is often the realistic fix.
Dropped valve seat destroys a cylinder (HEMI)
- What you'll notice
- A sudden misfire with a flashing check engine light, a loud metallic knock, loss of power, smoke from the exhaust, and in some cases the engine dying while you drive. The starter may spin unusually fast because a cylinder has lost compression.
- Why it happens
- The 5.7L HEMI uses valve seats pressed into its aluminum heads. If the head runs hot, often after a cooling problem, a seat can loosen and fall into the cylinder, smashing the valve, piston and cylinder wall.
- What to do
- Pull over and shut the engine off if it starts knocking hard; driving on it spreads the damage. Have a compression test done. Expect a cylinder head and possibly engine replacement, so get a written quote and compare a remanufactured engine with a repair.
Automatic transmission failure
- What you'll notice
- Whining from the transmission, then slipping, no reverse, or the car suddenly losing all drive and refusing to move, sometimes on the highway. Failures are reported anywhere from about 30,000 to over 180,000 miles.
- Why it happens
- The automatic transmissions in these cars wear out internally. Some owners also traced damage to coolant getting into the fluid through the transmission cooler in the radiator, or to failed speed sensors and control modules.
- What to do
- Check the transmission fluid; if it is pink and milky, coolant has mixed in and the radiator must be replaced along with the transmission repair. Have the codes read before agreeing to a rebuild, since a sensor can cause similar symptoms.
Engine stalls or cuts out while driving
- What you'll notice
- The engine suddenly shuts off in traffic, at a stop or even at highway speed, and steering becomes heavy. It may restart right away or only after sitting.
- Why it happens
- Owners and shops have traced it to failing crankshaft or camshaft position sensors, a faulty engine computer (PCM), or the fuel tank venting problem described separately. Often no single cause is confirmed.
- What to do
- Have the codes read as soon as possible after a stall, even if no light is on. Sensor replacement is cheap and is often tried first. Because stalling is a safety risk, avoid busy highways until it is found.
Takata air bag inflators can rupture (recall)
- What you'll notice
- Usually no symptom. The driver and passenger front air bags can explode with too much force in a crash and throw metal pieces into the cabin.
- Why it happens
- The Takata inflators break down after years of heat and humidity. Recalls 15V313 (driver) and 16V352 (passenger) cover these cars.
- What to do
- Ask the dealer to confirm the recall applies to your VIN and have the free replacement done right away if it is still open.
Free at a dealer under the recall.
Car may not hold in Park (recall)
- What you'll notice
- The shifter shows Park, but the car can roll because the park pawl does not lock the transmission.
- Why it happens
- A plug that holds the park pawl's anchor shaft may have been installed wrong, letting the shaft move. Recall 05V460 adds a retaining bracket.
- What to do
- Always use the parking brake, and have the free recall repair done if it is open.
Free at a dealer under the recall.
Rear brake lines can wear through (recall)
- What you'll notice
- Brake fluid leaking near the engine, a soft or sinking brake pedal, or the brake warning light.
- Why it happens
- On 2.7L cars a rear brake tube can rub against the EGR tube until it wears a hole. Recall 06V149 replaces the tubes and adds a clip.
- What to do
- If the pedal feels soft, do not drive the car. Check your VIN for this recall and get it fixed free.
Free at a dealer under the recall.
Gearshift cable can come off (recall)
- What you'll notice
- The shifter shows one gear while the transmission is in another, and the car could move when you expect it to stay put.
- Why it happens
- The gearshift cable can pop out of its bracket on the transmission. Recall 08V583 adds a locking clip.
- What to do
- Use the parking brake every time you park and have the free recall repair done.
Free at a dealer under the recall.
Shifter stuck in Park
- What you'll notice
- The engine starts but the gear lever will not come out of Park even with your foot on the brake. It may free up after a few tries or not at all, leaving you stranded.
- Why it happens
- A small pink plastic piece and its spring inside the shift-lock mechanism of the shifter break or come loose, so the lock never releases.
- What to do
- Pry off the trim beside the shifter and press the shift-lock release tab to get the car into gear in an emergency. For a lasting fix, have the shifter's shift-lock parts or the whole shifter assembly replaced, and check that the brake lights work, since the brake switch also controls the lock.
Stalls after filling the gas tank
- What you'll notice
- Shortly after refueling the engine stalls at a stop or while driving, or it takes a lot of cranking to start. The gas pump may also click off early.
- Why it happens
- Liquid fuel gets past the tank's fill and vent valve into the evaporative emissions canister and purge valve. That floods the engine with raw fuel vapor and can saturate the canister.
- What to do
- Stop filling at the first click and never top off. Have the evaporative system checked; repairs can include the tank vent valve, canister and purge solenoid, and in some cases the fuel tank.
Clunking front suspension and fast tie rod wear
- What you'll notice
- Clunks or thumps over bumps and road seams, a loose or wandering feel in the steering, and uneven front tire wear.
- Why it happens
- The front tension strut bushings, ball joints, control arm bushings, tie rods and sway bar links on these heavy cars wear out early. Owners often replace several parts before finding the worn one.
- What to do
- Have the whole front end inspected at once so the right part is found, then get an alignment. Worn tie rods and ball joints affect steering, so do not put it off.
Broken exhaust manifold bolts (HEMI)
- What you'll notice
- A ticking or tapping noise from the engine that is loudest on a cold start and fades as it warms up, sometimes with an exhaust smell.
- Why it happens
- Heat makes the HEMI's cast iron exhaust manifolds warp, which snaps the bolts, usually at the rear of the passenger side, and lets exhaust leak out.
- What to do
- Have a shop confirm where the tick comes from, since it can sound like a lifter problem. Replacing the broken bolts and gasket fixes it; extracting snapped bolts adds labor.
Gauges drop to zero while driving
- What you'll notice
- The speedometer, tachometer and other gauges suddenly fall to zero and warning lights flicker, then come back.
- Why it happens
- Communication faults in the front control module (FCM) and integrated power module, or in the instrument cluster, interrupt the signal to the gauges.
- What to do
- Note when it happens and have a shop scan all modules for stored communication codes. Software updates and module replacement are the usual fixes.
Repair prices for your 2006 Dodge Magnum
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace engine with a used or remanufactured 2.7L V6
- Replace engine with a remanufactured 5.7L HEMI
- Replace automatic transmission with a remanufactured unit
- Repair shift-lock or replace gear shifter assembly
- Replace crankshaft and camshaft position sensors
- Replace fuel tank vent valve, EVAP canister and purge valve
- Replace front tension strut bushings, tie rod ends and align
- Replace exhaust manifold bolts and gasket
- Replace instrument cluster (used or new) and set mileage
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall repair at a dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…