Your 1996 Ford Contourproblems, repair costs and recalls
What we've documented about the 1996 Ford Contour: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1996 Ford Contour
24 documented issues apply to 1996, most serious first.
Automatic transmission slipping or failing
- What you'll notice
- The car slips out of gear, loses gears, shifts late or harshly, or will not move forward. Many failures happen around 100,000-140,000 miles.
- Why it happens
- The CD4E automatic in the Contour has a known weakness, often starting with the front pump. Ford also issued bulletins for no forward drive and no overdrive on this transmission.
- What to do
- Check the fluid level and smell. If it slips or will not move, stop driving it hard and get a transmission diagnosis. On a car this age a used or rebuilt transmission is usually the most sensible fix.
Water pump failure and overheating
- What you'll notice
- Coolant leaking from the front of the engine, the temperature gauge climbing, steam, or the engine overheating. Some owners replaced the pump several times.
- Why it happens
- The water pump on these cars used a plastic impeller that can crack or break apart, and pump bearings and housings also failed. Ford sent owner notices about water pump bearing and housing failures.
- What to do
- Stop driving as soon as the gauge climbs, since overheating can ruin the head gasket. When replacing the pump, ask for one with a metal impeller.
Blower motor resistor can overheat and melt (recall)
- What you'll notice
- A burning plastic smell, some fan speeds stop working, or the blower quits. The connector may be melted.
- Why it happens
- The heater blower resistor could overheat and damage its wiring connector, causing arcing and a fire risk. Ford recalled these cars to replace the resistor and harness and also extended the warranty on earlier cars.
- What to do
- Stop using the fan if you smell burning. Check your VIN for the recall and have the resistor and connector replaced.
Recalls this old may no longer be done by dealers; ask with your VIN.
Rear brakes can lock up from a corroded valve (recall)
- What you'll notice
- The rear wheels lock or skid during hard braking, especially on cars driven on salted roads.
- Why it happens
- On cars without ABS, the rear brake pressure-reducing valves could corrode from road salt and stop working, letting the rear brakes lock. Ford recalled 1996-1998 cars and later added 1999-2000 cars.
- What to do
- Check your VIN for the recall and make sure the improved valves were installed.
Recalls this old may no longer be done by dealers; ask with your VIN.
Headlights can go out from an overheated switch (recall)
- What you'll notice
- The headlights or other lights flicker or suddenly go out, and the switch area may get hot.
- Why it happens
- Headlight switch terminals and the wiring connector could overheat and burn, cutting power to the lights. Ford recalled these cars to install a better connector and inspect or replace the switch.
- What to do
- If the lights flicker or go out, have the switch and connector checked right away.
Recalls this old may no longer be done by dealers; ask with your VIN.
Throttle cable can fray on traction control cars (recall)
- What you'll notice
- The engine does not return to idle when you lift off the gas.
- Why it happens
- On 1996 Contours with traction control, throttle cables damaged at the factory could fray or separate. Ford recalled these cars for new cables.
- What to do
- If the engine does not return to idle, shift to Neutral, brake and stop safely. Check your VIN for the recall.
Recalls this old may no longer be done by dealers; ask with your VIN.
Radiator fan motor can overheat (recall)
- What you'll notice
- A hot electrical smell from the engine bay, the fan not running, or the engine running hot in traffic.
- Why it happens
- The cooling fan motor bearings could overheat and create a fire risk. Ford added a protection device to the fan and extended its warranty on affected cars.
- What to do
- Check your VIN for the recall. If the fan is not running or you smell burning, have it checked before driving in traffic.
Recalls this old may no longer be done by dealers; ask with your VIN.
Timing belt shredding (2.0L)
- What you'll notice
- A slapping or rubbing noise from the front of the engine, or the engine suddenly stopping and not restarting.
- Why it happens
- Ford issued a bulletin for 2.0L Zetec timing belts shredding or hitting the front cover. If the belt breaks, the engine stops and can be damaged inside.
- What to do
- Replace the timing belt on schedule, around 120,000 miles, or sooner if you do not know when it was last done. Have any noise from the belt area checked right away.
Manual transmission differential failure (V6)
- What you'll notice
- Grinding or clunking from the transmission, then the car will not move even though the engine runs.
- Why it happens
- Ford issued bulletins about differential failures in the 5-speed manual on V6 cars, sometimes linked to hard launches.
- What to do
- Stop driving if you hear grinding from the transmission. A used transmission or a rebuild is usually needed.
Shifter gear indicator damaged by cleaners (recall)
- What you'll notice
- The P-R-N-D gear indicator on the shifter becomes hard to read or wrong, so you might pick the wrong gear.
- Why it happens
- Some interior cleaners could damage the shifter and its gear indicator. Ford recalled these cars to replace the shift control.
- What to do
- Always confirm the gear on the dash before letting off the brake. Check your VIN for the recall.
Recalls this old may no longer be done by dealers; ask with your VIN.
Fuel filler vent hose can crack and leak (recall)
- What you'll notice
- A gasoline smell around the rear of the car, especially after filling up.
- Why it happens
- The vent hose for the fuel filler could crack and leak fuel. Ford recalled these cars for a hose made from the correct material.
- What to do
- Do not ignore a fuel smell. Check your VIN for the recall and have the hose inspected.
Recalls this old may no longer be done by dealers; ask with your VIN.
Check engine light from clogged EGR passages
- What you'll notice
- The check engine light comes on with an EGR flow code, and the engine may ping or knock under load.
- Why it happens
- Carbon can plug the exhaust gas recirculation (EGR) passages so not enough exhaust flows back into the engine. Ford issued a bulletin for EGR flow codes on these cars.
- What to do
- Have the codes read. Cleaning the EGR passages and checking the EGR valve and sensor usually fixes it.
Lean codes from vacuum leaks (V6)
- What you'll notice
- The check engine light comes on with codes P0171 and P0174, and the idle may be rough.
- Why it happens
- Cracked vacuum hoses or leaking intake gaskets let in extra air, making the engine run lean. Ford issued a bulletin for these codes from vacuum leaks.
- What to do
- Have a shop do a smoke test to find the leak. It is usually a cheap hose or gasket.
Rough idle and stalling at idle
- What you'll notice
- The engine idles rough or unevenly, stalls when coming to a stop, or makes a hooting noise from the idle air valve when slowing down.
- Why it happens
- Dirty or failing idle air control valves and vacuum leaks are common causes. Ford issued bulletins for rough idle, stalling and noise from the idle air bypass valve.
- What to do
- Have the idle air control valve cleaned or replaced and check for vacuum leaks.
Will not crank in Park but starts in Neutral
- What you'll notice
- Turning the key in Park does nothing, but the car starts if you shift to Neutral.
- Why it happens
- Ford issued a bulletin for the CD4E automatic with this condition. A misadjusted or worn transmission range switch is a common cause.
- What to do
- Have the transmission range switch and shift linkage checked. Starting in Neutral is a workaround, but get it fixed.
Harsh shifts between gears
- What you'll notice
- A hard bang on the 1-3 upshift or the 3-2 downshift.
- Why it happens
- Ford issued a bulletin for harsh shifts on the CD4E automatic.
- What to do
- Check the fluid level and condition. Have a shop scan for codes and look at the bulletin fix before the transmission wears further.
Alternator failure and dead battery
- What you'll notice
- The battery light flickers or stays on, the battery keeps going dead, or the car will not start.
- Why it happens
- Ford issued bulletins for failed alternators, including corroded slip rings, and for discharged batteries on these cars.
- What to do
- Have the battery and alternator tested. Replace the alternator if it is not charging.
Heater core leak
- What you'll notice
- A sweet coolant smell inside, foggy windows, a wet passenger floor, or coolant slowly disappearing.
- Why it happens
- Ford issued a bulletin for heater core leaks on these cars. The heater core is behind the dashboard.
- What to do
- Check the coolant level and look for wet carpet. Replacing the core is a big job because much of the dash comes out.
Steering wheel shakes when braking
- What you'll notice
- The steering wheel or car vibrates when you brake, especially from highway speed.
- Why it happens
- Ford issued bulletins about brake vibration on these cars, usually from uneven front rotors and pad material.
- What to do
- Have the front rotors and pads inspected. New or resurfaced rotors and pads usually fix it.
Front wheel bearing noise
- What you'll notice
- A humming or growling noise that grows with speed and may change when turning.
- Why it happens
- Ford issued a bulletin for front wheel bearing noise on these cars.
- What to do
- Have the wheel bearings checked. A badly worn bearing can affect steering and braking.
Heat and A/C blow only from the defrost vents
- What you'll notice
- Air only comes out of the windshield vents no matter which setting you pick.
- Why it happens
- The vent doors are moved by vacuum. A leaking vacuum line or a link falling off a vacuum motor sends all the air to defrost. Ford issued bulletins for both.
- What to do
- Have a shop check the vacuum lines and vent door motors behind the dash.
Clunk from the front stabilizer bar links
- What you'll notice
- A clunk or rattle from the front when driving over bumps.
- Why it happens
- Ford issued a bulletin for front suspension noise from the stabilizer bar and its links.
- What to do
- Have the front sway bar links and bushings checked. They are cheap and quick to replace.
Water leaking onto the front floor
- What you'll notice
- Wet carpet on the front floor after rain or a car wash.
- Why it happens
- Ford issued a bulletin for water getting in around the door panel area and wetting the front floor.
- What to do
- Have the door water shield and seals checked and resealed. Dry the carpet quickly to prevent mold and rust.
Temperature gauge reads high when the engine is not hot
- What you'll notice
- The temperature gauge sits higher than normal even though the engine is not overheating.
- Why it happens
- Ford issued bulletins for temperature gauges reading high at normal operating temperature.
- What to do
- Make sure the engine is not really overheating first: check coolant level and the fan. Then have the sensor and gauge checked.
Repair prices for your 1996 Ford Contour
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace automatic transmission with used or rebuilt unit
- Replace water pump and refill coolant
- Clean EGR passages; replace EGR valve or sensor if needed
- Smoke test and replace vacuum hose or intake gasket
- Clean or replace idle air control valve
- Replace timing belt and tensioner
- Adjust or replace transmission range switch
- Transmission diagnosis and bulletin repair
- Replace manual transmission with used or rebuilt unit
- Replace alternator
- Replace heater core
- Repair vacuum lines or vent door vacuum motor
- Replace front brake pads and rotors
- Replace front wheel bearing
- Replace front stabilizer bar links
- Reseal door water shield
- Replace coolant temperature sender
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Free recall repair at a Ford dealerNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…