Your 1999 Ford Explorerproblems, repair costs and recalls
What we've documented about the 1999 Ford Explorer: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1999 Ford Explorer
3 documented issues apply to 1999, most serious first.
Cruise control deactivation switch can overheat and catch fire (recalls 09V-399, 07V-336, 06V-286)
- What you'll notice
- Smoke or a burning smell from under the hood near the brake master cylinder, sometimes with the vehicle parked and off.
- Why it happens
- The switch that turns off cruise control when you brake can leak brake fluid internally and overheat, which can start an engine-compartment fire.
- What to do
- Check the VIN for these recalls. If the switch has not been replaced or disconnected, have it done before parking the vehicle in or near a building.
Automatic slipping or missing gears (TSB 02-13-8)
- What you'll notice
- Slipping, a missing second or third gear, delayed shifts and a check-engine light with gear-ratio codes.
- Why it happens
- Low internal line pressure in the automatic transmission can keep clutches and bands from holding. Ford issued a service bulletin covering these years.
- What to do
- Have the transmission diagnosed and ask the shop about TSB 02-13-8. Catching it early may avoid a full rebuild.
Timing chain rattle from worn guides and tensioners
- What you'll notice
- A rattle or chatter from the engine for a few seconds at start-up, later turning into a constant rattle, often with a check-engine light for cam timing or a rough idle.
- Why it happens
- The single-overhead-cam 4.0L uses three timing chains with plastic guides and tensioners. The guides wear and break, letting the chains slap, and the rear chain sits at the back of the engine where repairs take a lot of labor.
- What to do
- Have a rattle diagnosed soon. If a guide breaks, the chain can jump timing and damage the engine, so repair it before it gets worse.
Repair prices for your 1999 Ford Explorer
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild automatic transmission
- Disconnect or replace switch and add fused jumper harness
- Replace timing chains, guides and tensioners
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…