Ford Focusproblems, repair costs and recalls
Problems reported across 2000–2018. Pick your model year below to see what applies to your vehicle.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems
22 documented issues across all years, most serious first.
Transmission control module failure
- What you'll notice
- The car drops into neutral or loses drive while moving, will not start or go into gear, or shows a transmission warning.
- Why it happens
- The transmission control module mounted on the gearbox can fail, often from heat or moisture. Ford extended coverage for this module.
- What to do
- Treat loss of drive as a safety issue. Have the module tested and check your VIN for extended coverage and reprogramming campaigns.
Door won't latch or bounces open
- What you'll notice
- A door-ajar warning while driving, or a door that will not stay closed.
- Why it happens
- A part inside the door latch can wear and stop catching. Ford recalled the latches and later expanded the campaign.
- What to do
- Do not drive with a door that will not latch. Check your VIN for open door latch recalls.
Valve seat can drop into the cylinder
- What you'll notice
- A sudden loud knocking or clattering, a hard misfire, heavy shaking and loss of power, often with no warning beforehand.
- Why it happens
- On the base single-cam engine, a pressed-in valve seat in the cylinder head can work loose and fall into the cylinder, where it gets hammered by the piston. Overheating makes it more likely.
- What to do
- Shut the engine off right away if this happens; running it does more damage. Never let this engine overheat, and have any misfire checked promptly.
Rear door may not latch fully and can open (recall)
- What you'll notice
- A rear door that needs slamming, sits slightly proud, or pops open while driving.
- Why it happens
- The rear door latches can fail to catch completely, so the door looks closed but is not secure. Ford recalled the latches.
- What to do
- Check your VIN for this recall. Do not carry rear passengers next to a door that does not latch firmly.
Clogged in-tank fuel filter can stall the engine (recall)
- What you'll notice
- Hesitation, surging and loss of power, worse in hot weather or with a low tank, and eventually stalling.
- Why it happens
- The filter on the fuel pump module inside the tank can plug up and starve the engine of fuel. Ford recalled affected cars.
- What to do
- Check your VIN for this recall. If the engine has started cutting out, have it fixed before driving in traffic.
Battery cables can short and overheat (recall)
- What you'll notice
- A check engine light, a no-start, a hot plastic smell, or smoke and melted wiring near the battery.
- Why it happens
- The battery cables can rub through and short circuit, which can overheat the wiring and start a fire. Ford recalled affected cars.
- What to do
- Check your VIN for this recall. If you see smoke or smell melting plastic, stop driving and have it towed.
Rear wheel hub nuts can loosen (recall)
- What you'll notice
- Clunking or a wobble from a rear wheel.
- Why it happens
- On some early cars the nuts holding the rear hubs were not secure, which could let a rear wheel come loose. Ford recalled them.
- What to do
- Check your VIN for this recall and have any rear wheel looseness inspected before driving further.
Cruise control cable can hold the throttle open (recalls)
- What you'll notice
- The engine keeps pulling after you lift off the gas pedal, so the car does not slow down as expected.
- Why it happens
- The cruise control cable can snag and stop the throttle from closing fully. Ford ran two recalls on it.
- What to do
- If it happens, brake firmly, shift to Neutral and pull over. Check your VIN for these recalls.
Front suspension pinch bolts can loosen (recall)
- What you'll notice
- Noise and vibration from the front end over bumps or when turning.
- Why it happens
- The pinch bolts that clamp the front ball joints may not stay tight. Left alone, the joint can come apart or the ball joint stud can break. Ford recalled affected cars.
- What to do
- Check your VIN for this recall and have front-end clunks inspected promptly.
Engine dies while driving
- What you'll notice
- The engine quits with no warning, sometimes at a stop light and sometimes at speed, and may restart after a wait.
- Why it happens
- Owners trace it to the fuel delivery and idle control side of the engine, with the fuel pump or throttle body often behind it.
- What to do
- Do not ignore it. Losing the engine in traffic is dangerous, so have the fuel pressure and throttle body checked.
Oil pump belt can fail and kill oil pressure (recall)
- What you'll notice
- The oil pressure light comes on, the engine may stall, and the brake pedal gets hard right after.
- Why it happens
- The belt that drives the oil pump, or its tensioner, can fail, so the pump stops circulating oil.
- What to do
- Stop driving as soon as the oil light comes on. Without oil pressure the engine can be destroyed in minutes.
Manual transmission clutch can break and leak fluid (recall)
- What you'll notice
- A burning smell, fluid dripping near the transmission, or a clutch pedal that goes soft on a manual car.
- Why it happens
- A clutch component can fracture and let clutch fluid escape onto hot engine and exhaust parts, where it can catch fire.
- What to do
- Park it and have the clutch inspected if you smell burning or see a leak.
Engine block heater can crack and leak (recall)
- What you'll notice
- Coolant under the front of the car, a blown fuse or tripped outlet when the heater is plugged in, or a burning smell.
- Why it happens
- The block heater can crack, which lets coolant reach its electrical connection and short it out.
- What to do
- Stop using the block heater and have it replaced. A short there can start a fire.
PowerShift automatic shudders and slips
- What you'll notice
- Shuddering or jerking when pulling away from a stop, hesitation, slipping, or fluid leaking near the clutch housing.
- Why it happens
- This automatic uses dry clutches like a manual. Leaking input shaft seals contaminate the clutches and worn clutches grab unevenly. Ford extended warranty coverage and a class action settlement followed.
- What to do
- Have a Ford dealer inspect the clutches, seals, and software. Check whether your VIN still has extended transmission coverage.
Stalling after refueling or crushed fuel tank
- What you'll notice
- Stalling or rough running, especially right after filling up, a fuel gauge that reads wrong, or a check engine light for the evaporative system.
- Why it happens
- A stuck-open canister purge valve can pull too much vacuum on the fuel tank and deform it. Ford recalled these cars to replace the valve and check the tank.
- What to do
- Check your VIN for the purge valve recall. A shop can confirm the codes and inspect the tank.
Key will not turn in the ignition
- What you'll notice
- The key goes in but will not turn, or it sticks and will not come back out. It tends to get worse until the car cannot be started.
- Why it happens
- The small tumblers inside the ignition lock cylinder wear and jam.
- What to do
- Do not force the key, which can break it off. Have the lock cylinder replaced before it leaves you stranded.
Engine vibration from a worn top engine mount
- What you'll notice
- Strong vibration through the steering wheel, seats and dash at idle or in gear at a stop, sometimes with a thump when you pull away.
- Why it happens
- The upper engine mount on the passenger side wears out or its fluid-filled center leaks, so engine shake passes straight into the body.
- What to do
- Have the engine mounts inspected. It is not an emergency, but a failed mount puts extra strain on the other mounts and the exhaust.
Rear wheel bearings wear out early
- What you'll notice
- A humming or rumbling from the back of the car that gets louder with speed.
- Why it happens
- The rear wheel bearings on early cars can wear sooner than expected. Federal safety regulators opened an inquiry into them.
- What to do
- Have the rear bearings checked for play and noise. Do not ignore a growling bearing for long, since a badly worn one can loosen the wheel.
Rear end noise with uneven rear tire wear
- What you'll notice
- Clunks or a rumble from the back over bumps, and the inside or outside edges of the rear tires wear down long before the tread should be gone.
- Why it happens
- Worn rear suspension bushings and shocks let the rear wheels change angle, so the tires scrub as the car rolls.
- What to do
- Have the rear suspension checked and the alignment measured before you buy another set of tires.
Hatch can unlatch from one press of the inside release (recall)
- What you'll notice
- The rear hatch pops open from a single touch of the inside release, which rear passengers can reach.
- Why it happens
- The hatch release circuit can unlatch the hatch with one press instead of requiring the normal action.
- What to do
- Have the release reprogrammed or replaced, and keep children from reaching it until then.
Rear seat back weld may be weak (recall)
- What you'll notice
- Nothing is noticed day to day; the left rear seat back may feel less solid than it should.
- Why it happens
- A weak weld can let the rear seat back give way under crash loads.
- What to do
- Have the seat back inspected and replaced so it protects passengers in a crash.
Ignition switch and lock cylinder wear out
- What you'll notice
- The key will not turn, or only turns if you push it in hard, jiggle it, or pull on the steering wheel, and it can take many attempts before the engine cranks.
- Why it happens
- The tumblers in the lock cylinder and the housing behind them wear until the key no longer reaches the point where it closes the circuit. Owners report the same failure coming back after a repair that replaced only part of the assembly.
- What to do
- Try your spare key first to rule out a worn key, then have the lock cylinder and the ignition switch replaced as a set. Do not ignore it, because a switch this worn can also cut out and stall the engine.
Repair prices for your Ford Focus
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace dual clutch assembly and input shaft seals
- Replace and program transmission control module
- Replace canister purge valve and update engine software
- Replace door latch
- Replace cylinder head (or engine if cylinder is damaged)
- Replace ignition lock cylinder
- Replace upper (passenger side) engine mount
- Replace rear wheel bearing/hub (one side)
- Replace rear door latch (one door)
- Replace fuel delivery module
- Replace battery cable assembly
- Replace rear hub retaining nuts
- Replace speed control cable
- Replace front ball joint pinch bolts
- Replace rear shocks and bushings, then align
- Test fuel pressure, replace fuel pump or clean throttle body
- Replace oil pump belt and tensioner
- Replace clutch assembly and clutch fluid line
- Replace engine block heater and element
- Reprogram or replace rear hatch release
- Replace left rear seat back frame
- Replace ignition lock cylinder and ignition switch
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Pick a model year to see its safety recalls.