Home › GMC › Canyon › 2010
My vehicle

Your 2010 GMC Canyonproblems, repair costs and recalls

What we've documented about the 2010 GMC Canyon: problems owners and shops report, typical repair and upkeep costs, and safety recalls.

Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.

Ownership snapshot

Averages, not quotes
Problems documented for 201092 rated serious
Safety recalls…Checking NHTSA

Routine maintenance costs (model-wide, not specific to one year or engine)

Synthetic oil and filter changeEvery 5,000–7,500 miles or when the oil-life monitor says · The 2.8L Duramax diesel needs diesel-rated oil and costs more.
Price not verified
Ask for an estimate
Front brake pads and rotorsAbout every 30,000–60,000 miles
Price not verified
Ask for an estimate
Rear brakes (pads and rotors or shoes and drums)About every 40,000–70,000 miles · Many Canyons use rear drum brakes with shoes, which usually last longer.
Price not verified
Ask for an estimate
12V battery replacementAbout every 3–5 years · 2023 and newer trucks with stop-start use an AGM battery.
Price not verified
Ask for an estimate
Spark plug replacement (gas engines)About every 60,000–100,000 miles · V6 and V8 models take longer. The 2.8L diesel has no spark plugs.
Price not verified
Ask for an estimate
Coolant (DEX-COOL) drain and refillAbout every 150,000 miles or 5 years
Price not verified
Ask for an estimate

The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.

Known problems for your 2010 GMC Canyon

9 documented issues apply to 2010, most serious first.

Stop soon2004–2012Transmission

4-speed automatic slips or loses gears

What you'll notice
The engine revs but the truck doesn't speed up, shifts come late or hard, or the truck gets stuck in a low gear and won't shift into 3rd or 4th.
Why it happens
The 4L60-E automatic used in these trucks wears its internal clutches and parts, especially with towing, heat or old fluid. Loss of 3rd and 4th gear is a classic failure of this transmission.
What to do
Check the fluid level and smell. If it slips or won't shift, have it diagnosed before driving much farther, because more damage raises the rebuild cost.
Repair costInsufficient verified pricing for this vehicle and repair
Rebuild or replace 4L60-E automatic transmission. Prepare an itemized shop request.
Walk through this symptom: Transmission slipping →
Stop soon2010–2012Body

Hood may be missing its secondary latch (recall)

What you'll notice
Usually nothing until the main latch lets go; then the hood can fly open while driving.
Why it happens
Some trucks were built without the backup hood latch required by federal rules.
What to do
Check your VIN for open recalls. The dealer fixes it free.
Typical repair costNo charge if your vehicle is in the recall
Replace hood with secondary latch (recall)
Get checked2004–2012HVAC

Blower fan works only on some speeds or not at all

What you'll notice
The heater and A/C fan stops blowing, or works only on certain speeds (often only high). You may smell hot plastic near the passenger footwell.
Why it happens
The blower motor resistor fails, and the heat can melt its wiring connector. This is the most-reported problem on first-generation Canyons, usually around 90,000 miles.
What to do
Replace the resistor and check its connector for melting. If the connector is burned, replace it too, or the new resistor can fail again.
Repair costInsufficient verified pricing for this vehicle and repair
Replace blower motor resistor and wiring connector. Prepare an itemized shop request.
Get checked2004–2012Electrical

Passlock security light and engine won't crank

What you'll notice
The engine won't turn over, or it cranks and won't start, and a security or Passlock light shows on the dash. It may happen now and then at first, then every day.
Why it happens
The anti-theft system stops seeing the right signal from the ignition, usually because the ignition switch or the Passlock sensor in the steering column has failed or corroded.
What to do
A shop can read the security codes to confirm it. Replacing the ignition switch or the Passlock sensor usually fixes it; the parts are not expensive.
Repair costInsufficient verified pricing for this vehicle and repair
Replace ignition switch or Passlock sensor. Prepare an itemized shop request.
Walk through this symptom: Car won't start →
Get checked2004–2012Engine2.8L, 2.9L 4-cylinder / 3.5L, 3.7L 5-cylinder

Timing chain rattle at startup

What you'll notice
A rattle from the engine for a few seconds after a cold start. If the chain stretches further you may see a check engine light, a rough idle, misfires or less power.
Why it happens
The timing chain stretches or its tensioner loses pressure over time, especially when oil changes are skipped or the oil is low.
What to do
Do not ignore a rattle that gets longer or louder. Have the codes checked; replacing the chain, guides and tensioner early costs far less than repairing a jumped timing chain.
Repair costInsufficient verified pricing for this vehicle and repair
Replace timing chain, guides and tensioner. Prepare an itemized shop request.
Get checked2004–2012Engine2.8L, 2.9L 4-cylinder / 3.5L, 3.7L 5-cylinder

Cam phaser (VVT actuator) rattle and rough running

What you'll notice
A rattle on startup, a check engine light with cam timing codes such as P0017, a rough idle or misfires.
Why it happens
The variable valve timing actuator on the camshaft, or the oil control solenoid that feeds it, wears or gets clogged with sludge, so cam timing goes out of range.
What to do
Have the codes read. Sometimes only the inexpensive solenoid is needed; a worn actuator costs more. Fresh oil at the right level helps prevent it.
Repair costInsufficient verified pricing for this vehicle and repair
Replace cam phaser oil control solenoid or actuator. Prepare an itemized shop request.
Walk through this symptom: Engine sputters or misfires →
Get checked2004–2012Electrical

Random electrical problems from corroded grounds

What you'll notice
Power windows or locks quit, lights act up, gauges flicker, or the truck sometimes won't start, with no clear pattern.
Why it happens
Ground wire splice packs under the hood corrode, and a weak body control module ground can cause several systems to misbehave at once.
What to do
Have a shop check the battery, then the ground splices and body control module ground before replacing expensive modules.
Get checked2004–2012Body

Frame and body rust

What you'll notice
Bubbling paint and rust on the cab corners, rocker panels and bed, and scaly rust on the frame rails that can turn into holes.
Why it happens
Salted winter roads and years of outdoor parking let rust take hold, especially on trucks used for work.
What to do
Have the frame inspected on a lift, especially before buying. Frame holes are a safety problem and can fail inspection.
Repair costInsufficient verified pricing for this vehicle and repair
Rust repair on body panels or frame sections. Prepare an itemized shop request.
Monitor2004–2012Emissions

EVAP leak or gas cap check engine light

What you'll notice
Check engine light, sometimes with a 'Check fuel cap' message. Codes are often P0455 or P0449/P0450. The truck drives normally.
Why it happens
A worn gas cap that no longer seals, or a sticking EVAP vent valve or canister, lets the fuel vapor system fail its self-test.
What to do
Make sure the cap clicks tight first. If the light comes back, have the code read; a new cap or vent valve is a cheap fix.
Repair costInsufficient verified pricing for this vehicle and repair
Replace gas cap, EVAP vent valve or canister. Prepare an itemized shop request.
Walk through this symptom: Check engine light on →
Price guide

Repair prices for your 2010 GMC Canyon

Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.

  • Rebuild or replace 4L60-E automatic transmission
  • Replace blower motor resistor and wiring connector
  • Replace ignition switch or Passlock sensor
  • Replace timing chain, guides and tensioner
  • Replace cam phaser oil control solenoid or actuator
  • Replace gas cap, EVAP vent valve or canister
  • Rust repair on body panels or frame sections

Recall repairs: usually free at the dealer

A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.

  • Replace hood with secondary latchNo charge if your vehicle is included
Get help with a shop quote →

Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.

Safety recalls for the 2010 GMC Canyon
Checking the NHTSA recall database…
Keep a copy of this pageDownload the snapshot, every problem, the repair costs and the recalls for your 2010 GMC Canyon as a PDF you can save, print or bring to your shop.
This page is a general guide based on widely reported problems. Not every vehicle is affected, and it doesn't replace an in-person diagnosis.