Your 2012 GMC Sierra 1500problems, repair costs and recalls
What we've documented about the 2012 GMC Sierra 1500: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2012 GMC Sierra 1500
3 documented issues apply to 2012, most serious first.
Cylinder deactivation lifter can collapse
- What you'll notice
- A tick or tap from the top of the engine that does not go away when it warms up, a shaky idle, the check engine light on with a misfire on one cylinder, and sometimes a clear loss of power.
- Why it happens
- The special lifters that shut cylinders off under light load can stick or collapse; a collapsed lifter stops opening its valve, can bend the pushrod and can wear the camshaft lobe flat.
- What to do
- Get it diagnosed right away and keep driving to a minimum - once the camshaft lobe is damaged, a lifter job turns into a camshaft and sometimes a whole-engine job.
Heavy oil consumption
- What you'll notice
- You need to add a quart or more between oil changes, the low-oil light comes on, and you may see blue smoke at startup or feel a misfire.
- Why it happens
- Piston rings on this version of the 5.3L can clog, partly linked to the cylinder-shutoff fuel-saving system spraying oil. Oil gets past the rings and burns. GM issued bulletins and a class action followed.
- What to do
- Check the dipstick at every fill-up and keep the oil full. Ask a dealer about GM's oil consumption bulletins; repairs may involve new pistons and rings.
Clunk in the steering at low speed
- What you'll notice
- A clunk or bump felt through the steering wheel during slow turns, like in parking lots, or looseness in the steering.
- Why it happens
- The intermediate steering shaft has a sliding joint that dries out and wears. GM offered a re-grease kit, and worn shafts are replaced.
- What to do
- Have the steering shaft checked so other causes like worn tie rods are ruled out. Lubricating or replacing the shaft usually stops the clunk.
Repair prices for your 2012 GMC Sierra 1500
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace intermediate steering shaft
- Replace pistons and rings and AFM oil shield
- Replace lifters, pushrods and camshaft on one bank
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…