Your 2003 GMC Sierra 2500HDproblems, repair costs and recalls
What we've documented about the 2003 GMC Sierra 2500HD: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 GMC Sierra 2500HD
6 documented issues apply to 2003, most serious first.
Duramax fuel injectors leak or crack
- What you'll notice
- White or gray smoke, rough idle, hard starting, a rising oil level that smells like diesel, or a 'balance rate' code.
- Why it happens
- The early LB7 Duramax injectors are known to crack and leak fuel into the cylinders or the oil.
- What to do
- Check the oil level and smell; fuel in the oil can wipe out the bearings. A full set of injectors is the usual fix.
Rusted brake lines can burst
- What you'll notice
- The brake pedal suddenly sinks toward the floor, a brake warning light, or wet brake fluid along the frame.
- Why it happens
- The steel brake lines run along the frame and rust through in salted-road areas. Federal regulators investigated this on GM trucks of this era.
- What to do
- Have the lines inspected on a lift every year. If any are heavily rusted, replace them before one bursts.
Broken exhaust manifold bolts
- What you'll notice
- A ticking noise on cold start that fades as the engine warms, or an exhaust smell.
- Why it happens
- Heat cycles cause the exhaust manifold bolts on the 6.0L V8 to snap, which lets exhaust leak.
- What to do
- Have it fixed before the leak burns nearby wiring or the manifold warps. Broken bolts often need to be drilled out.
Duramax water pump leaks
- What you'll notice
- Coolant drips at the front of the engine, a dropping coolant level or a sweet smell.
- Why it happens
- The water pump seal on early Duramax engines wears and leaks.
- What to do
- Keep the coolant topped off and replace the pump before the engine overheats.
Clunk felt in the steering wheel
- What you'll notice
- A clunk or knock you feel in the wheel when turning at low speed or going over bumps.
- Why it happens
- The sliding intermediate steering shaft loses its lubrication and binds. GM issued a bulletin for it.
- What to do
- It's mostly an annoyance, but have the steering checked for loose parts. Lubricating or replacing the shaft fixes it.
Instrument cluster gauges stick or quit
- What you'll notice
- The speedometer, fuel or temperature gauges stick or drop to zero.
- Why it happens
- Small stepper motors behind each gauge fail. GM extended coverage on many of these clusters at the time.
- What to do
- A cluster repair shop can replace the motors.
Repair prices for your 2003 GMC Sierra 2500HD
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace all eight fuel injectors
- Replace rusted brake lines (full preformed line set)
- Replace intermediate steering shaft
- Extract broken bolts, replace manifold bolts and gasket
- Rebuild instrument cluster (replace gauge stepper motors)
- Replace water pump and coolant
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…