Home › GMC › Sierra 2500HD › 2013
My vehicle

Your 2013 GMC Sierra 2500HDproblems, repair costs and recalls

What we've documented about the 2013 GMC Sierra 2500HD: problems owners and shops report, typical repair and upkeep costs, and safety recalls.

Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.

Ownership snapshot

Averages, not quotes
Problems documented for 201342 rated serious
Safety recalls…Checking NHTSA

Routine maintenance costs (model-wide, not specific to one year or engine)

Oil and filter change (gas or diesel)Every 5,000–7,500 miles or when the oil-life monitor says · Duramax diesels hold about 10 quarts of diesel-rated oil, so they cost more.
Price not verified
Ask for an estimate
Front brake pads and rotorsAbout every 30,000–50,000 miles · On some older 4WD trucks the front rotors sit behind the hub, which adds labor.
Price not verified
Ask for an estimate
Rear brake pads and rotorsAbout every 40,000–60,000 miles
Price not verified
Ask for an estimate
12V battery replacementAbout every 3–5 years · Duramax diesels use two batteries, usually replaced together.
Price not verified
Ask for an estimate
Spark plug replacement (gas V8)About every 97,500 miles on gas V8s · Gas engines only. Duramax diesels have no spark plugs.
Price not verified
Ask for an estimate
Coolant (DEX-COOL) drain and refillAbout every 150,000 miles or 5 years
Price not verified
Ask for an estimate

The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.

Known problems for your 2013 GMC Sierra 2500HD

4 documented issues apply to 2013, most serious first.

Stop soon2011–2016Fuel6.6L Duramax diesel (LML)

High-pressure diesel fuel pump fails and contaminates the fuel system

What you'll notice
The engine dies or won't start, often with no warning, sometimes after a long crank. It often happens around 100,000 miles.
Why it happens
The LML Duramax uses a Bosch CP4.2 high-pressure pump that can wear internally, especially with poor or water-contaminated fuel. When it fails it sends metal through the injectors and fuel lines.
What to do
Have it towed rather than cranking it repeatedly. Expect the injectors, lines and tank to need cleaning or replacing along with the pump. Use quality fuel and change fuel filters on time to lower the risk.
Repair costInsufficient verified pricing for this vehicle and repair
Replace high-pressure pump, injectors, lines and flush fuel system. Prepare an itemized shop request.
Stop soon2007–2014Safety

Passenger front air bag inflator can rupture (recalls)

What you'll notice
No warning before a crash.
Why it happens
Takata-made passenger inflators can break apart when they deploy, sending metal fragments into the cabin. Several recalls cover these years.
What to do
Check your VIN for open recalls and get it fixed right away. Dealers replace the inflator free.
Typical repair costNo charge if your vehicle is in the recall
Replace passenger air bag inflator (recall)
Get checked2011–2016Emissions6.6L Duramax diesel (LML)

DEF and NOx sensor warnings with a speed-limit countdown

What you'll notice
A DEF warning, 'Service Emission System' message, check engine light, and a countdown that limits speed if it isn't fixed.
Why it happens
The NOx sensors, DEF heater and pump on the diesel exhaust system fail over time.
What to do
Have the codes read soon so the truck doesn't go into limp mode. A sensor is the most common fix.
Repair costInsufficient verified pricing for this vehicle and repair
Replace NOx sensor or DEF system part. Prepare an itemized shop request.
Get checked1999–2019Exhaust6.0L V8

Broken exhaust manifold bolts

What you'll notice
A ticking noise on cold start that fades as the engine warms, or an exhaust smell.
Why it happens
Heat cycles cause the exhaust manifold bolts on the 6.0L V8 to snap, which lets exhaust leak.
What to do
Have it fixed before the leak burns nearby wiring or the manifold warps. Broken bolts often need to be drilled out.
Repair costInsufficient verified pricing for this vehicle and repair
Extract broken bolts, replace manifold bolts and gasket. Prepare an itemized shop request.
Price guide

Repair prices for your 2013 GMC Sierra 2500HD

Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.

  • Replace high-pressure pump, injectors, lines and flush fuel system
  • Replace NOx sensor or DEF system part
  • Extract broken bolts, replace manifold bolts and gasket

Recall repairs: usually free at the dealer

A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.

  • Replace passenger air bag inflatorNo charge if your vehicle is included
Get help with a shop quote →

Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.

Safety recalls for the 2013 GMC Sierra 2500HD
Checking the NHTSA recall database…
Keep a copy of this pageDownload the snapshot, every problem, the repair costs and the recalls for your 2013 GMC Sierra 2500HD as a PDF you can save, print or bring to your shop.
This page is a general guide based on widely reported problems. Not every vehicle is affected, and it doesn't replace an in-person diagnosis.