Home › Hummer › H3 › 2006
My vehicle

Your 2006 Hummer H3problems, repair costs and recalls

What we've documented about the 2006 Hummer H3: problems owners and shops report, typical repair and upkeep costs, and safety recalls.

Ownership snapshot

Averages, not quotes
Problems documented for 2006166 rated serious
Safety recalls…Checking NHTSA

Routine maintenance costs (model-wide, not specific to one year or engine)

Oil and filter changeEvery 5,000-7,500 miles (follow the oil life monitor)
Price not verified
Ask for an estimate
Front brake pads and rotorsAbout every 30,000-50,000 miles
Price not verified
Ask for an estimate
Rear brake pads and rotorsAbout every 40,000-60,000 miles
Price not verified
Ask for an estimate
12V battery replacementAbout every 4-6 years
Price not verified
Ask for an estimate
Spark plugs (5 or 8)About every 100,000 miles · The V8 needs eight plugs and takes longer.
Price not verified
Ask for an estimate
Engine coolant drain and refill (Dex-Cool)About every 5 years or 150,000 miles
Price not verified
Ask for an estimate

The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.

Known problems for your 2006 Hummer H3

16 documented issues apply to 2006, most serious first.

Stop soon2006–2008Engine3.5L / 3.7L 5-cylinder

Misfire from worn valve seats in the cylinder head

What you'll notice
A flashing or steady check engine light, rough idle, shaking, poor acceleration and worse fuel economy. Codes often point to one cylinder, commonly No. 2, 3 or 5.
Why it happens
The exhaust valve seats in the 5-cylinder engine’s aluminum head wear or recede, so a valve no longer seals and the cylinder loses compression. It is the best-known H3 engine problem and some heads were replaced under warranty.
What to do
Have a compression or leak-down test done to confirm it. A new or rebuilt cylinder head is the usual fix; a head swap can fail again if the root cause is not addressed, so use a shop that knows these engines.
Repair costInsufficient verified pricing for this vehicle and repair
Replace cylinder head (new or remanufactured) with gaskets. Prepare an itemized shop request.
Walk through this symptom: Engine sputters or misfires →
Stop soon2006–2010HVAC

Blower motor connector can overheat (recall)

What you'll notice
A burning smell from behind the glove box, smoke, the fan working only on some speeds, or melted wiring at the blower resistor.
Why it happens
The module that controls blower fan speed and its connector can overheat, melting the wiring and creating a fire risk. GM recalled 2006-2010 H3 and 2009-2010 H3T trucks to replace part of the connector and harness.
What to do
Have a GM dealer run your VIN and do the free recall repair. If the fan acts up or you smell burning plastic, turn the fan off until it is fixed.
Typical repair costNo charge if your vehicle is in the recall
Recall: replace blower motor connector and harness section
If the recall cannot be done, owners report paying for a new resistor and harness; ask for a written quote.
Stop soon2006–2010Body

Hood louver can come loose and fly off (recall)

What you'll notice
A rattle from the hood vent at speed, and in some reports the plastic hood louver breaking free and hitting the windshield.
Why it happens
Clips holding the decorative louver to the hood can break. GM recalled the trucks to glue the louver in place, but some owners say it came off again later.
What to do
Make sure the recall is done, and check the louver for looseness after car washes or off-road trips.
Typical repair costNo charge if your vehicle is in the recall
Recall: bond hood louver to hood with adhesive
Stop soon2006Fuel

Fuel pump failure (stalls or will not start)

What you'll notice
The engine cranks but will not start, or it shuts off while driving; you may not hear the pump hum when the key is turned on.
Why it happens
The in-tank fuel pump or its relay fails. Some owners also report rusted pump and tank parts.
What to do
Have fuel pressure tested to confirm the pump is the cause before replacing it.
Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel pump module. Prepare an itemized shop request.
Walk through this symptom: Engine stalls while driving →
Stop soon2006Suspension

Rear leaf spring cracks or breaks

What you'll notice
A bang or clunk from the rear, the truck leaning to one side, or the rear wheel shifting and wobbling.
Why it happens
The rear leaf springs can crack near their front mounting eye, especially when rust has weakened the mounts.
What to do
Have the springs and mounts inspected if the rear sits unevenly. Replace springs in pairs.
Repair costInsufficient verified pricing for this vehicle and repair
Replace rear leaf springs (pair) and hardware. Prepare an itemized shop request.
Stop soon2006–2008Body

Frame and spring mount rust

What you'll notice
Visible scaling rust on the frame, rotted spring mounts, or holes in the frame near the rear axle.
Why it happens
Owners in salt-belt states report the frame and rear spring mounts rusting badly enough to worry about the axle or frame failing.
What to do
Have the frame inspected before buying an older H3. Severe frame rust can make the truck unsafe and expensive to repair.
Repair costInsufficient verified pricing for this vehicle and repair
Weld-repair frame or spring mounts. Prepare an itemized shop request.
Get checked2006–2008Cooling

Radiator plastic tank cracks and leaks coolant

What you'll notice
Coolant drips or puddles under the front, a sweet smell, the low coolant light, or the engine overheating.
Why it happens
The plastic tanks on the H3’s radiator crack, often at the top. It is one of the most-reported H3 repairs in owner surveys, on both the 5-cylinder and V8.
What to do
Keep an eye on the coolant level and temperature gauge. Replace a cracked radiator before it overheats the engine, which can ruin the cylinder head.
Repair costInsufficient verified pricing for this vehicle and repair
Get checked2006–2008Cooling

Thermostat sticks (overheating or check engine light)

What you'll notice
The temperature gauge runs high or low, the heater is weak, or the check engine light comes on.
Why it happens
The thermostat can stick open or closed. Owners of several H3 years report replacing it for overheating or a check engine light.
What to do
Have the cooling system checked; a thermostat is inexpensive compared with the damage overheating can do.
Repair costInsufficient verified pricing for this vehicle and repair
Replace thermostat and refill coolant. Prepare an itemized shop request.
Walk through this symptom: Check engine light on →
Get checked2006–2008Electrical

Will not start, security light on (theft-system lockout)

What you'll notice
The truck cranks but will not start or will not crank, a security or anti-theft light or message appears, and it starts again after waiting 10 to 20 minutes.
Why it happens
The theft-deterrent system loses the signal from the ignition lock cylinder and disables starting. A worn lock cylinder or switch is often blamed.
What to do
Leave the key on for about 10 minutes until the security light goes off, then try again. Have a shop check the ignition lock cylinder and theft system for a lasting fix.
Repair costInsufficient verified pricing for this vehicle and repair
Replace ignition lock cylinder or switch and relearn. Prepare an itemized shop request.
Walk through this symptom: Security light flashing, won't start →
Get checked2006–2008Body

Sunroof drains clog and leak water inside

What you'll notice
Wet headliner, water on the seats or floor, musty smell, or warning lights after rain.
Why it happens
The sunroof drain tubes plug up and water overflows into the cabin. Water reaching wiring and sensors can set ABS or stability control warnings.
What to do
Clear the sunroof drains regularly. Dry wet carpet quickly to avoid mold and electrical damage.
Repair costInsufficient verified pricing for this vehicle and repair
Clear sunroof drain tubes and dry interior. Prepare an itemized shop request.
Walk through this symptom: Water inside the car →
Get checked2006–2010Suspension

Front wheel bearing wear

What you'll notice
A humming or growling noise that grows with speed, a loose feel in the steering, or an ABS light.
Why it happens
Front wheel bearing and hub assemblies are among the most common H3 repairs reported by owners.
What to do
Have the noise checked. Replace a failing bearing before it gets loose enough to affect steering.
Repair costInsufficient verified pricing for this vehicle and repair
Replace front wheel hub and bearing assembly (one side). Prepare an itemized shop request.
Walk through this symptom: Humming noise at speed →
Get checked2006–2010Drivetrain

CV axle or joint wear (clicking on turns)

What you'll notice
Clicking or popping when turning, vibration, or grease thrown around the inside of the wheel.
Why it happens
The front CV axles and joints wear out, often after a torn boot lets dirt in. They are one of the more common H3 repairs.
What to do
Inspect CV boots at each oil change; a torn boot caught early can save the axle.
Repair costInsufficient verified pricing for this vehicle and repair
Replace front CV axle shaft. Prepare an itemized shop request.
Get checked2006–2008HVAC

Heater or A/C controls stop adjusting temperature

What you'll notice
Temperature will not change, the A/C does not cool, or the climate control buttons and lights stop working.
Why it happens
The climate control head or its module fails. Some owners also need A/C expansion valves.
What to do
Have the HVAC system scanned. The control head is often the fix if the blower works but the temperature will not change.
Repair costInsufficient verified pricing for this vehicle and repair
Replace HVAC control head. Prepare an itemized shop request.
Get checked2006Drivetrain

4WD transfer case will not shift

What you'll notice
The 4WD will not engage or disengage, or the drivetrain locks up.
Why it happens
The transfer case shift motor can fail, and one owner reported a plastic shift fork breaking.
What to do
Have the 4WD system scanned. A shift motor is a far cheaper fix than internal transfer case repairs.
Repair costInsufficient verified pricing for this vehicle and repair
Replace transfer case shift motor. Prepare an itemized shop request.
Monitor2006–2010Emissions

Check engine light from gas cap or EVAP valve

What you'll notice
The check engine light comes on with no change in how the truck drives, sometimes coming back after a new gas cap.
Why it happens
A worn gas cap seal or a failed EVAP vent solenoid or canister lets fuel vapor escape, which the computer reads as a leak.
What to do
Tighten or replace the gas cap first. If the light returns, have the EVAP system smoke-tested to find the leak.
Repair costInsufficient verified pricing for this vehicle and repair
Replace gas cap or EVAP vent solenoid. Prepare an itemized shop request.
Walk through this symptom: Check engine light on →
Monitor2006–2007Engine3.5L / 3.7L 5-cylinder

Camshaft sensor or cam timing codes

What you'll notice
Check engine light with cam timing or sensor codes, sometimes rough running.
Why it happens
The camshaft position sensor or the cam timing (phaser) solenoid can fail on the 5-cylinder engines.
What to do
Check the oil level and change the oil if it is old, since cam timing parts rely on clean oil. Then have the sensor or solenoid tested.
Repair costInsufficient verified pricing for this vehicle and repair
Replace camshaft position sensor or cam phaser solenoid. Prepare an itemized shop request.
Price guide

Repair prices for your 2006 Hummer H3

Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.

  • Replace cylinder head (new or remanufactured) with gaskets
  • Replace radiator
  • Replace thermostat and refill coolant
  • Replace gas cap or EVAP vent solenoid
  • Replace ignition lock cylinder or switch and relearn
  • Replace fuel pump module
  • Clear sunroof drain tubes and dry interior
  • Replace rear leaf springs (pair) and hardware
  • Weld-repair frame or spring mounts
  • Replace front wheel hub and bearing assembly (one side)
  • Replace front CV axle shaft
  • Replace HVAC control head
  • Replace camshaft position sensor or cam phaser solenoid
  • Replace transfer case shift motor

Recall repairs: usually free at the dealer

A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.

  • Recall: replace blower motor connector and harness sectionNo charge if your vehicle is included
  • Recall: bond hood louver to hood with adhesiveNo charge if your vehicle is included
Get help with a shop quote →

Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.

Safety recalls for the 2006 Hummer H3
Checking the NHTSA recall database…
Keep a copy of this pageDownload the snapshot, every problem, the repair costs and the recalls for your 2006 Hummer H3 as a PDF you can save, print or bring to your shop.
This page is a general guide based on widely reported problems. Not every vehicle is affected, and it doesn't replace an in-person diagnosis.