Your 2007 Hummer H3problems, repair costs and recalls
What we've documented about the 2007 Hummer H3: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Hummer H3
17 documented issues apply to 2007, most serious first.
Misfire from worn valve seats in the cylinder head
- What you'll notice
- A flashing or steady check engine light, rough idle, shaking, poor acceleration and worse fuel economy. Codes often point to one cylinder, commonly No. 2, 3 or 5.
- Why it happens
- The exhaust valve seats in the 5-cylinder engine’s aluminum head wear or recede, so a valve no longer seals and the cylinder loses compression. It is the best-known H3 engine problem and some heads were replaced under warranty.
- What to do
- Have a compression or leak-down test done to confirm it. A new or rebuilt cylinder head is the usual fix; a head swap can fail again if the root cause is not addressed, so use a shop that knows these engines.
Blower motor connector can overheat (recall)
- What you'll notice
- A burning smell from behind the glove box, smoke, the fan working only on some speeds, or melted wiring at the blower resistor.
- Why it happens
- The module that controls blower fan speed and its connector can overheat, melting the wiring and creating a fire risk. GM recalled 2006-2010 H3 and 2009-2010 H3T trucks to replace part of the connector and harness.
- What to do
- Have a GM dealer run your VIN and do the free recall repair. If the fan acts up or you smell burning plastic, turn the fan off until it is fixed.
If the recall cannot be done, owners report paying for a new resistor and harness; ask for a written quote.
Hood louver can come loose and fly off (recall)
- What you'll notice
- A rattle from the hood vent at speed, and in some reports the plastic hood louver breaking free and hitting the windshield.
- Why it happens
- Clips holding the decorative louver to the hood can break. GM recalled the trucks to glue the louver in place, but some owners say it came off again later.
- What to do
- Make sure the recall is done, and check the louver for looseness after car washes or off-road trips.
Frame and spring mount rust
- What you'll notice
- Visible scaling rust on the frame, rotted spring mounts, or holes in the frame near the rear axle.
- Why it happens
- Owners in salt-belt states report the frame and rear spring mounts rusting badly enough to worry about the axle or frame failing.
- What to do
- Have the frame inspected before buying an older H3. Severe frame rust can make the truck unsafe and expensive to repair.
Radiator plastic tank cracks and leaks coolant
- What you'll notice
- Coolant drips or puddles under the front, a sweet smell, the low coolant light, or the engine overheating.
- Why it happens
- The plastic tanks on the H3’s radiator crack, often at the top. It is one of the most-reported H3 repairs in owner surveys, on both the 5-cylinder and V8.
- What to do
- Keep an eye on the coolant level and temperature gauge. Replace a cracked radiator before it overheats the engine, which can ruin the cylinder head.
Water pump leaks or fails
- What you'll notice
- Coolant leaking near the front of the engine, a whining or grinding noise, or overheating.
- Why it happens
- The water pump bearing or seal wears out. Several 3.7L owners report replacing it at roughly 55,000 to 120,000 miles.
- What to do
- Replace a leaking pump soon; overheating is especially hard on this engine’s cylinder head.
Thermostat sticks (overheating or check engine light)
- What you'll notice
- The temperature gauge runs high or low, the heater is weak, or the check engine light comes on.
- Why it happens
- The thermostat can stick open or closed. Owners of several H3 years report replacing it for overheating or a check engine light.
- What to do
- Have the cooling system checked; a thermostat is inexpensive compared with the damage overheating can do.
Will not start, security light on (theft-system lockout)
- What you'll notice
- The truck cranks but will not start or will not crank, a security or anti-theft light or message appears, and it starts again after waiting 10 to 20 minutes.
- Why it happens
- The theft-deterrent system loses the signal from the ignition lock cylinder and disables starting. A worn lock cylinder or switch is often blamed.
- What to do
- Leave the key on for about 10 minutes until the security light goes off, then try again. Have a shop check the ignition lock cylinder and theft system for a lasting fix.
Sunroof drains clog and leak water inside
- What you'll notice
- Wet headliner, water on the seats or floor, musty smell, or warning lights after rain.
- Why it happens
- The sunroof drain tubes plug up and water overflows into the cabin. Water reaching wiring and sensors can set ABS or stability control warnings.
- What to do
- Clear the sunroof drains regularly. Dry wet carpet quickly to avoid mold and electrical damage.
Catalytic converter bracket or bolts break
- What you'll notice
- A rattle or exhaust leak noise from under the truck, sometimes with a check engine light.
- Why it happens
- On the 5-cylinder, the catalytic converter bracket and bolts can break; one owner also had bolts snap in the head and needed a new head and converter.
- What to do
- Have broken brackets fixed early so the exhaust is not hanging on the manifold studs.
Front wheel bearing wear
- What you'll notice
- A humming or growling noise that grows with speed, a loose feel in the steering, or an ABS light.
- Why it happens
- Front wheel bearing and hub assemblies are among the most common H3 repairs reported by owners.
- What to do
- Have the noise checked. Replace a failing bearing before it gets loose enough to affect steering.
CV axle or joint wear (clicking on turns)
- What you'll notice
- Clicking or popping when turning, vibration, or grease thrown around the inside of the wheel.
- Why it happens
- The front CV axles and joints wear out, often after a torn boot lets dirt in. They are one of the more common H3 repairs.
- What to do
- Inspect CV boots at each oil change; a torn boot caught early can save the axle.
Heater or A/C controls stop adjusting temperature
- What you'll notice
- Temperature will not change, the A/C does not cool, or the climate control buttons and lights stop working.
- Why it happens
- The climate control head or its module fails. Some owners also need A/C expansion valves.
- What to do
- Have the HVAC system scanned. The control head is often the fix if the blower works but the temperature will not change.
Battery drains overnight (door switch or seat button)
- What you'll notice
- A dead battery after the truck sits, interior lights or the info display staying on, or doors showing open when closed.
- Why it happens
- A corroded door switch can keep lights and modules awake, and a cracked seat trim piece pressing a power seat button drained one owner’s battery.
- What to do
- Watch whether the dome light or door-ajar message stays on. Clean or replace the faulty door switch and test for a parasitic drain.
Check engine light from gas cap or EVAP valve
- What you'll notice
- The check engine light comes on with no change in how the truck drives, sometimes coming back after a new gas cap.
- Why it happens
- A worn gas cap seal or a failed EVAP vent solenoid or canister lets fuel vapor escape, which the computer reads as a leak.
- What to do
- Tighten or replace the gas cap first. If the light returns, have the EVAP system smoke-tested to find the leak.
Camshaft sensor or cam timing codes
- What you'll notice
- Check engine light with cam timing or sensor codes, sometimes rough running.
- Why it happens
- The camshaft position sensor or the cam timing (phaser) solenoid can fail on the 5-cylinder engines.
- What to do
- Check the oil level and change the oil if it is old, since cam timing parts rely on clean oil. Then have the sensor or solenoid tested.
Fuel gauge reads empty after filling
- What you'll notice
- The fuel gauge shows low or empty right after a fill-up, then reads normally later.
- Why it happens
- The fuel level sender in the tank or its circuit gives a bad reading.
- What to do
- Track mileage between fill-ups until it is fixed so you do not run out of fuel.
Repair prices for your 2007 Hummer H3
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace cylinder head (new or remanufactured) with gaskets
- Replace radiator
- Replace water pump and coolant
- Replace thermostat and refill coolant
- Replace gas cap or EVAP vent solenoid
- Replace ignition lock cylinder or switch and relearn
- Clear sunroof drain tubes and dry interior
- Weld-repair frame or spring mounts
- Replace catalytic converter bracket and bolts (or converter)
- Replace front wheel hub and bearing assembly (one side)
- Replace front CV axle shaft
- Replace HVAC control head
- Replace camshaft position sensor or cam phaser solenoid
- Find parasitic drain; clean or replace door switch
- Replace fuel level sender
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Recall: replace blower motor connector and harness sectionNo charge if your vehicle is included
- Recall: bond hood louver to hood with adhesiveNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…