Home › Hummer › H3 › 2010
My vehicle

Your 2010 Hummer H3problems, repair costs and recalls

What we've documented about the 2010 Hummer H3: problems owners and shops report, typical repair and upkeep costs, and safety recalls.

Ownership snapshot

Averages, not quotes
Problems documented for 201052 rated serious
Safety recalls…Checking NHTSA

Routine maintenance costs (model-wide, not specific to one year or engine)

Oil and filter changeEvery 5,000-7,500 miles (follow the oil life monitor)
Price not verified
Ask for an estimate
Front brake pads and rotorsAbout every 30,000-50,000 miles
Price not verified
Ask for an estimate
Rear brake pads and rotorsAbout every 40,000-60,000 miles
Price not verified
Ask for an estimate
12V battery replacementAbout every 4-6 years
Price not verified
Ask for an estimate
Spark plugs (5 or 8)About every 100,000 miles · The V8 needs eight plugs and takes longer.
Price not verified
Ask for an estimate
Engine coolant drain and refill (Dex-Cool)About every 5 years or 150,000 miles
Price not verified
Ask for an estimate

The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.

Known problems for your 2010 Hummer H3

5 documented issues apply to 2010, most serious first.

Stop soon2006–2010HVAC

Blower motor connector can overheat (recall)

What you'll notice
A burning smell from behind the glove box, smoke, the fan working only on some speeds, or melted wiring at the blower resistor.
Why it happens
The module that controls blower fan speed and its connector can overheat, melting the wiring and creating a fire risk. GM recalled 2006-2010 H3 and 2009-2010 H3T trucks to replace part of the connector and harness.
What to do
Have a GM dealer run your VIN and do the free recall repair. If the fan acts up or you smell burning plastic, turn the fan off until it is fixed.
Typical repair costNo charge if your vehicle is in the recall
Recall: replace blower motor connector and harness section
If the recall cannot be done, owners report paying for a new resistor and harness; ask for a written quote.
Stop soon2006–2010Body

Hood louver can come loose and fly off (recall)

What you'll notice
A rattle from the hood vent at speed, and in some reports the plastic hood louver breaking free and hitting the windshield.
Why it happens
Clips holding the decorative louver to the hood can break. GM recalled the trucks to glue the louver in place, but some owners say it came off again later.
What to do
Make sure the recall is done, and check the louver for looseness after car washes or off-road trips.
Typical repair costNo charge if your vehicle is in the recall
Recall: bond hood louver to hood with adhesive
Get checked2006–2010Suspension

Front wheel bearing wear

What you'll notice
A humming or growling noise that grows with speed, a loose feel in the steering, or an ABS light.
Why it happens
Front wheel bearing and hub assemblies are among the most common H3 repairs reported by owners.
What to do
Have the noise checked. Replace a failing bearing before it gets loose enough to affect steering.
Repair costInsufficient verified pricing for this vehicle and repair
Replace front wheel hub and bearing assembly (one side). Prepare an itemized shop request.
Walk through this symptom: Humming noise at speed →
Get checked2006–2010Drivetrain

CV axle or joint wear (clicking on turns)

What you'll notice
Clicking or popping when turning, vibration, or grease thrown around the inside of the wheel.
Why it happens
The front CV axles and joints wear out, often after a torn boot lets dirt in. They are one of the more common H3 repairs.
What to do
Inspect CV boots at each oil change; a torn boot caught early can save the axle.
Repair costInsufficient verified pricing for this vehicle and repair
Replace front CV axle shaft. Prepare an itemized shop request.
Monitor2006–2010Emissions

Check engine light from gas cap or EVAP valve

What you'll notice
The check engine light comes on with no change in how the truck drives, sometimes coming back after a new gas cap.
Why it happens
A worn gas cap seal or a failed EVAP vent solenoid or canister lets fuel vapor escape, which the computer reads as a leak.
What to do
Tighten or replace the gas cap first. If the light returns, have the EVAP system smoke-tested to find the leak.
Repair costInsufficient verified pricing for this vehicle and repair
Replace gas cap or EVAP vent solenoid. Prepare an itemized shop request.
Walk through this symptom: Check engine light on →
Price guide

Repair prices for your 2010 Hummer H3

Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.

  • Replace gas cap or EVAP vent solenoid
  • Replace front wheel hub and bearing assembly (one side)
  • Replace front CV axle shaft

Recall repairs: usually free at the dealer

A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.

  • Recall: replace blower motor connector and harness sectionNo charge if your vehicle is included
  • Recall: bond hood louver to hood with adhesiveNo charge if your vehicle is included
Get help with a shop quote →

Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.

Safety recalls for the 2010 Hummer H3
Checking the NHTSA recall database…
Keep a copy of this pageDownload the snapshot, every problem, the repair costs and the recalls for your 2010 Hummer H3 as a PDF you can save, print or bring to your shop.
This page is a general guide based on widely reported problems. Not every vehicle is affected, and it doesn't replace an in-person diagnosis.