Your 1996 Mazda Protegeproblems, repair costs and recalls
What we've documented about the 1996 Mazda Protege: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 1996 Mazda Protege
4 documented issues apply to 1996, most serious first.
Ignition switch can overheat (recall)
- What you'll notice
- A burning smell or smoke from the steering column, accessories that cut in and out, or in the worst case a fire, even while the car is parked.
- Why it happens
- Grease inside the ignition switch can break down and start conducting electricity, which can overheat the switch. Mazda recalled these cars in 2015 and replaces the switch for free.
- What to do
- Ask a Mazda dealer to confirm the recall applies to your VIN and get the free switch replacement. If you smell burning near the steering column, stop using the car until it is fixed.
Poor engine performance
- What you'll notice
- The engine feels weak, hesitates or runs poorly.
- Why it happens
- Mazda issued a bulletin for poor engine performance on these years.
- What to do
- Have the codes read and ask a dealer about the bulletin repair. Also check the spark plugs, wires and air filter.
Noise from the drive shafts
- What you'll notice
- A clicking, knocking or humming noise from the front axles, often when turning or accelerating.
- Why it happens
- Mazda issued a bulletin for drive shaft noise on these years. Worn CV joints are a common cause.
- What to do
- Check the CV boots for tears and grease. A clicking joint should be replaced before it fails.
Check engine light from the EGR sensor circuit (P0400)
- What you'll notice
- Check engine light with code P0400 under certain loads and speeds.
- Why it happens
- Mazda issued a bulletin saying electrical noise in the EGR boost sensor circuit can set this code on 1995-1996 Proteges.
- What to do
- Ask a shop to check the EGR sensor wiring and the bulletin repair before replacing the EGR valve.
Repair prices for your 1996 Mazda Protege
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace front CV axle
- Diagnose and tune up (plugs, wires, filters)
- Diagnose and repair EGR sensor wiring
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace ignition switchNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…