Your 2003 Mazda Protegeproblems, repair costs and recalls
What we've documented about the 2003 Mazda Protege: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Mazda Protege
10 documented issues apply to 2003, most serious first.
Alternator or voltage regulator failure
- What you'll notice
- Battery light on, dim or flickering lights, a battery that keeps going dead, or a car that stalls while driving.
- Why it happens
- The voltage regulator built into the alternator can fail and overcharge or undercharge, which can also ruin the battery. Alternator failures are among the most reported repairs on this car.
- What to do
- Have the battery and charging system tested. If the alternator is overcharging, replace it before it kills a new battery.
Front brake calipers stick
- What you'll notice
- The car pulls to one side when braking, a burning smell or hot wheel after driving, grinding, or pads wearing out quickly on one side.
- Why it happens
- Front calipers corrode and stick, so the pads keep rubbing. This is the most-reported problem on 2002 Proteges and the top repair in owner surveys.
- What to do
- Have the brakes inspected. A sticking caliper should be replaced with new pads, and the brake fluid flushed if it is old.
Broken engine mounts
- What you'll notice
- Heavy vibration at idle, a clunk when shifting into drive or reverse, or a jolt when you step on the gas.
- Why it happens
- The rubber engine mounts crack and wear out with age, letting the engine move too much.
- What to do
- Have the mounts checked. A broken mount is not an emergency but it strains other parts, so replace it soon.
Wheel bearing hum
- What you'll notice
- A humming or growling noise that gets louder with speed and may change when you turn.
- Why it happens
- Wheel bearings and hub assemblies wear out; owners report them often on the Protege.
- What to do
- Have it checked soon. A badly worn bearing can overheat and fail.
Radiator or water pump leak
- What you'll notice
- Coolant puddles under the front of the car, a sweet smell, the temperature gauge climbing, or low coolant.
- Why it happens
- The radiator, water pump and thermostat are common cooling system repairs on the Protege as it ages.
- What to do
- Do not drive if the engine overheats. Have the cooling system pressure tested to find the leak.
Body rust
- What you'll notice
- Bubbling paint and rust, often around the rear wheel arches and lower body.
- Why it happens
- Rust is a known weak spot on this generation, especially in states that salt the roads.
- What to do
- Treat small spots early. Have the underbody and brake lines checked for rust on older cars.
Clunk over bumps from worn struts or stabilizer links
- What you'll notice
- Clunking or knocking from the front or rear when going over bumps, and a bouncy or floaty ride.
- Why it happens
- Struts, stabilizer bar end links and bushings wear out and are among the most common repairs on this car. Mazda also issued a bulletin for a rear stabilizer bar clunk on 2001-2002 models.
- What to do
- Have the suspension inspected. End links and bushings are cheap fixes; worn struts should be replaced in pairs.
High idle with check engine light (P0507)
- What you'll notice
- The engine idles too fast, often revving high right after starting, with a check engine light and code P0507.
- Why it happens
- Mazda issued a bulletin for code P0507 (idle speed higher than expected) on 2001-2003 Proteges. Dirty idle air control parts or vacuum leaks are common causes.
- What to do
- Have the idle air control valve and throttle body cleaned and check for vacuum leaks.
Oil leak from the valve cover gasket
- What you'll notice
- Oil on the top or side of the engine, a burning oil smell, or oil in the spark plug wells causing a misfire.
- Why it happens
- The valve cover gasket and spark plug tube seals harden with age and leak.
- What to do
- Replace the gasket and seals; it is a fairly cheap job.
Blower fan works only on high
- What you'll notice
- The heater and A/C fan works only on the highest setting, or not at all.
- Why it happens
- The blower motor resistor, which controls the lower fan speeds, burns out.
- What to do
- Replace the blower motor resistor; it is usually an easy, cheap part.
Repair prices for your 2003 Mazda Protege
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace alternator
- Replace front calipers and pads
- Replace engine mount
- Replace stabilizer links and bushings, or struts
- Replace front wheel bearing
- Clean throttle body and idle air control valve
- Replace radiator or water pump and refill coolant
- Replace valve cover gasket and plug tube seals
- Replace blower motor resistor
- Repair rust on rear wheel arches
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…