Your 2004 Mercedes-Benz CLKproblems, repair costs and recalls
What we've documented about the 2004 Mercedes-Benz CLK: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2004 Mercedes-Benz CLK
9 documented issues apply to 2004, most serious first.
Harsh shifts, limp mode or fluid leak at the transmission plug
- What you'll notice
- Hard or delayed shifts (often the 2-3 shift), slow engagement into Drive or Reverse, or the car getting stuck in 2nd gear with little power. Some cars show transmission fluid around the wiring plug on the side of the gearbox.
- Why it happens
- The 5-speed automatic uses a circuit board inside the gearbox (the conductor plate) with speed sensors that fail with age. The plug where the wiring enters the case can also leak fluid, which can creep up the harness toward the control unit. Old or low fluid makes shifting worse.
- What to do
- Have the transmission scanned for codes and check the fluid level and condition. A leaking plug is cheap to reseal; a failed conductor plate can often be replaced without rebuilding the whole gearbox.
Engine stalls or won't restart when hot (crank sensor)
- What you'll notice
- The engine cuts out while driving and then won't restart until it cools down, or it cranks for a long time before starting. Stalling at idle can happen too.
- Why it happens
- The crankshaft position sensor tells the engine computer where the crankshaft is. When it starts to fail, usually with heat, the computer loses that signal and shuts off spark and fuel.
- What to do
- If the engine stalls, get safely off the road. Have the codes read; this sensor is a common and fairly cheap part on these engines and is often the first thing to check.
Misfire from failing ignition coils
- What you'll notice
- Rough idle (often worst when cold), a loss of power when accelerating, a flashing or steady check engine light with misfire codes, and sometimes a fuel smell.
- Why it happens
- The ignition coils on this V6 wear out with heat and age. This engine also has two spark plugs per cylinder, so worn plugs add to the strain on the coils.
- What to do
- Have the misfire codes read to find which coil is weak. Many shops replace the coils and all 12 spark plugs together. Avoid cheap no-name coils.
Front control arm and thrust arm bushings crack
- What you'll notice
- Clunking from the front over bumps or when braking, vague or wandering steering, the car pulling to one side, and uneven tire wear.
- Why it happens
- The rubber bushings in the front control arms and thrust (tension) arms crack and wear out. Some are oil-filled and leak when they fail.
- What to do
- Have the front suspension inspected. Replace worn arms or bushings and then get a wheel alignment.
Worn tie rod ends and suspension joints
- What you'll notice
- Knocking or looseness in the steering, wandering on the highway, and tires wearing on the edges.
- Why it happens
- Tie rod ends, ball joints and other suspension joints wear with mileage and rough roads. Worn joints and bushings are the most common inspection failure on these cars in UK testing data.
- What to do
- Have the steering and suspension joints checked for play. Replace worn parts and get an alignment afterward.
Fuel gauge reads wrong or fuel pump fails
- What you'll notice
- The fuel gauge reads empty after filling up, sticks at full, or jumps around; in some cases the engine stalls or won't start because the pump has failed.
- Why it happens
- The fuel level sending units in the tank wear out, and the fuel pump can fail with age. Owners of both generations report replacing these parts.
- What to do
- Use the trip meter to track fuel until the gauge is fixed so you don't run out. Have the sender and pump tested before replacing parts.
Convertible top leaks hydraulic fluid or stops working
- What you'll notice
- The top moves slowly, stops partway or won't move. You may find hydraulic fluid in the trunk or behind the rear seats, damp carpets after rain, or a soft-top warning light.
- Why it happens
- The top is moved by hydraulic rams whose seals wear out after about 15 years. Cables, position switches and a sensor in the windshield latch can also fail.
- What to do
- Don't keep cycling a top that is leaking fluid. Have a convertible specialist find the leaking ram or failed switch; rebuilding rams is often cheaper than buying new ones.
Power window regulator fails
- What you'll notice
- A window that moves slowly, makes grinding or clicking noises, drops into the door, or won't go up at all. On convertibles, a stuck window can also stop the top from working.
- Why it happens
- The window regulator uses cables and plastic slides that stretch, crack or come loose with age. The driver's window and the rear windows on convertibles wear out most.
- What to do
- If a window won't close, cover it to keep rain out and have the regulator replaced. After repair, the window and top may need to be reset with a scan tool.
Air conditioning blows warm
- What you'll notice
- Weak or warm air from the vents, or cold air only on one side.
- Why it happens
- Common causes are a refrigerant leak at the receiver-drier hose, a failed evaporator temperature sensor, a stuck blend door actuator, and on high-mileage cars a worn compressor.
- What to do
- Have the A/C system checked for leaks and codes before recharging it. Recharging without fixing a leak wastes money.
Repair prices for your 2004 Mercedes-Benz CLK
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace transmission conductor plate and plug adapter, refill fluid
- Replace crankshaft position sensor
- Replace ignition coils and spark plugs (12 plugs)
- Replace front control arm or thrust arm (with bushings), then align
- Replace tie rod ends, then align
- Replace window regulator and motor
- Replace fuel pump and fuel level sending unit
- Replace A/C evaporator temperature sensor and recharge
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…