Your 2007 Mercedes-Benz CLKproblems, repair costs and recalls
What we've documented about the 2007 Mercedes-Benz CLK: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Mercedes-Benz CLK
7 documented issues apply to 2007, most serious first.
Balance shaft or timing idler gear wears out
- What you'll notice
- The check engine light comes on, often with camshaft timing codes P0016 or P0017. At first the light may come and go and the engine runs normally; later it stays on and the engine can shake or rattle.
- Why it happens
- On many V6 and V8 engines built from about 2005 into 2007, a timing gear (the balance shaft sprocket on the V6, the idler gear on the V8) was made from metal that was too soft. Its teeth wear down, so the timing chain slips out of step with the crankshaft.
- What to do
- Have the codes read and ask a Mercedes dealer to check whether your engine serial number is in the affected range. Don't ignore it for long: if the teeth strip, the engine can be badly damaged. The repair is a big job, so get a firm quote.
Front control arm and thrust arm bushings crack
- What you'll notice
- Clunking from the front over bumps or when braking, vague or wandering steering, the car pulling to one side, and uneven tire wear.
- Why it happens
- The rubber bushings in the front control arms and thrust (tension) arms crack and wear out. Some are oil-filled and leak when they fail.
- What to do
- Have the front suspension inspected. Replace worn arms or bushings and then get a wheel alignment.
Worn tie rod ends and suspension joints
- What you'll notice
- Knocking or looseness in the steering, wandering on the highway, and tires wearing on the edges.
- Why it happens
- Tie rod ends, ball joints and other suspension joints wear with mileage and rough roads. Worn joints and bushings are the most common inspection failure on these cars in UK testing data.
- What to do
- Have the steering and suspension joints checked for play. Replace worn parts and get an alignment afterward.
Fuel gauge reads wrong or fuel pump fails
- What you'll notice
- The fuel gauge reads empty after filling up, sticks at full, or jumps around; in some cases the engine stalls or won't start because the pump has failed.
- Why it happens
- The fuel level sending units in the tank wear out, and the fuel pump can fail with age. Owners of both generations report replacing these parts.
- What to do
- Use the trip meter to track fuel until the gauge is fixed so you don't run out. Have the sender and pump tested before replacing parts.
Convertible top leaks hydraulic fluid or stops working
- What you'll notice
- The top moves slowly, stops partway or won't move. You may find hydraulic fluid in the trunk or behind the rear seats, damp carpets after rain, or a soft-top warning light.
- Why it happens
- The top is moved by hydraulic rams whose seals wear out after about 15 years. Cables, position switches and a sensor in the windshield latch can also fail.
- What to do
- Don't keep cycling a top that is leaking fluid. Have a convertible specialist find the leaking ram or failed switch; rebuilding rams is often cheaper than buying new ones.
Power window regulator fails
- What you'll notice
- A window that moves slowly, makes grinding or clicking noises, drops into the door, or won't go up at all. On convertibles, a stuck window can also stop the top from working.
- Why it happens
- The window regulator uses cables and plastic slides that stretch, crack or come loose with age. The driver's window and the rear windows on convertibles wear out most.
- What to do
- If a window won't close, cover it to keep rain out and have the regulator replaced. After repair, the window and top may need to be reset with a scan tool.
Air conditioning blows warm
- What you'll notice
- Weak or warm air from the vents, or cold air only on one side.
- Why it happens
- Common causes are a refrigerant leak at the receiver-drier hose, a failed evaporator temperature sensor, a stuck blend door actuator, and on high-mileage cars a worn compressor.
- What to do
- Have the A/C system checked for leaks and codes before recharging it. Recharging without fixing a leak wastes money.
Repair prices for your 2007 Mercedes-Benz CLK
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace balance shaft or idler gear, timing chain and related parts
- Replace front control arm or thrust arm (with bushings), then align
- Replace tie rod ends, then align
- Replace window regulator and motor
- Replace fuel pump and fuel level sending unit
- Replace A/C evaporator temperature sensor and recharge
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…