Your 2004 Mercedes-Benz S-Classproblems, repair costs and recalls
What we've documented about the 2004 Mercedes-Benz S-Class: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2004 Mercedes-Benz S-Class
10 documented issues apply to 2004, most serious first.
Air suspension (Airmatic) sagging overnight
- What you'll notice
- One corner or one end of the car sits low after parking, the car is slow to rise after starting, a 'Car too low' or suspension warning appears, or the ride turns harsh and bouncy.
- Why it happens
- The rubber air springs in the Airmatic struts crack and leak with age, usually after 60,000 to 100,000 miles. Torn dust boots let dirt in and speed this up, and the rear springs often go first. A faulty rear height sensor can also make the rear drop.
- What to do
- Don't drive far if the car is sitting on its bump stops or a 'Stop vehicle' message shows. Have the leaking strut found with a leak test and replaced quickly, because a leak makes the compressor overwork and fail too.
Active Body Control (ABC) hydraulic leak or pump failure
- What you'll notice
- An ABC warning message, a corner that drops quickly, a hard or bouncy ride, too much body lean, red hydraulic fluid under the car, or a howl from the engine bay at low revs. Applies to S600, AMG and other cars ordered with ABC.
- Why it happens
- The ABC system uses high-pressure hydraulic fluid instead of air. Its hoses and seals age, the pressure accumulators wear out after about 10 years or 60,000 miles, and neglected fluid wears the pump, valve blocks and struts.
- What to do
- Stop and check the fluid level if a red ABC warning appears; driving with a burst hose can run the pump dry. Have a specialist read the ABC fault log and check the fluid condition before replacing parts.
ABC suspension high-pressure hose can corrode and leak (recall)
- What you'll notice
- Hydraulic fluid leaking near the front of the car, an ABC warning, or the car sinking and riding harshly.
- Why it happens
- The steel inner layer of an ABC high-pressure hose could corrode from humidity and start leaking fluid. Mercedes recalled affected cars with Active Body Control to fit a corrosion-resistant hose.
- What to do
- Ask a Mercedes dealer to check your VIN for open recall work. If fluid is leaking, have the car towed rather than driven.
Air suspension compressor running constantly or burned out
- What you'll notice
- A loud humming from behind the front bumper that runs a long time, the car taking ages to lift, or the car staying down with a 'Vehicle too low' warning.
- Why it happens
- The compressor wears internally and can no longer build enough pressure. It usually fails early because a leaking air spring or valve block made it run far longer than it was designed to. A stuck relay can also keep it running until it burns out.
- What to do
- Find and fix any air leak before or at the same time as replacing the compressor, or the new one will fail too. Ask the shop to replace the compressor relay as well.
Rust on body panels and subframe
- What you'll notice
- Bubbling paint or rust on door bottoms, wheel arches, the trunk lid, or rust on the subframe underneath.
- Why it happens
- Mercedes used a water-based paint and steel with weak corrosion protection in this era, and the body was not fully galvanized until early 2003. The 2007 to 2009 cars can also rust in salted-road areas; later cars are better protected.
- What to do
- Have the underside and subframe inspected, especially before buying. Treat small spots early; structural rust on the subframe is a bigger and more expensive job.
Transmission fluid leak at the electrical plug
- What you'll notice
- Red fluid dripping from the side of the transmission, low fluid, or erratic shifting and limp mode.
- Why it happens
- The 5-speed automatic has an electrical connector that passes through the case. Its plastic adapter and O-rings harden and leak fluid.
- What to do
- Have the connector adapter and seals replaced and the fluid topped up. This is a cheap part; don't ignore it, because low fluid damages the transmission.
Crankshaft position sensor failure
- What you'll notice
- The engine stalls while driving, cranks but won't start (often when hot), or runs rough with a check engine light.
- Why it happens
- The crankshaft position sensor tells the engine computer when to fire. Heat breaks it down over time and it stops sending a signal.
- What to do
- Have the codes read. The sensor is inexpensive and a common cause of no-starts on these cars.
Water leaking into cabin or trunk
- What you'll notice
- Wet carpets, water in the trunk spare-tire well, a damp smell, fogged windows, or electrical faults after rain.
- Why it happens
- The sunroof drain tubes clog with debris and overflow, and taillight seals can let water into the trunk. Water then reaches modules and wiring.
- What to do
- Clear the sunroof drains and check the taillight seals. Dry the carpets quickly and have any wet modules checked before they corrode.
V12 misfire from ignition coils or spark plugs
- What you'll notice
- Rough idle, shaking, misfires and a flashing or steady check engine light.
- Why it happens
- The V12s have 24 spark plugs and coil packs that each fire six cylinders. These wear out, and the tight engine bay makes the work slow and costly.
- What to do
- Have the misfire codes read. Don't drive long with a flashing check engine light, as unburned fuel can damage the catalytic converters.
Power windows or door locks stop working
- What you'll notice
- A window won't go up or down, moves slowly, or a door won't lock or unlock with the key fob, most often the driver's door.
- Why it happens
- The heavy double-pane glass wears out window motors and regulators on older cars. Door control modules can corrode or fail internally, and lock actuators wear out.
- What to do
- Have the door panel removed and the regulator, motor, lock actuator or door module tested. Some door module repairs need a Mercedes-level scan tool to code the new part.
Repair prices for your 2004 Mercedes-Benz S-Class
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace one leaking Airmatic air strut
- Replace Airmatic compressor and relay
- Repair ABC leak (hose, accumulator or strut) or replace ABC pump
- Body rust repair or subframe rust treatment
- Replace window regulator/motor or door lock actuator
- Replace transmission connector adapter and seals, top up fluid
- Replace crankshaft position sensor
- Clear sunroof drains and reseal taillights
- Replace V12 spark plugs and failed coil packs
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace ABC high-pressure hose under recallNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…