Your 2011 Mercedes-Benz S-Classproblems, repair costs and recalls
What we've documented about the 2011 Mercedes-Benz S-Class: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2011 Mercedes-Benz S-Class
9 documented issues apply to 2011, most serious first.
Air suspension (Airmatic) sagging overnight
- What you'll notice
- One corner or one end of the car sits low after parking, the car is slow to rise after starting, a 'Car too low' or suspension warning appears, or the ride turns harsh and bouncy.
- Why it happens
- The rubber air springs in the Airmatic struts crack and leak with age, usually after 60,000 to 100,000 miles. Torn dust boots let dirt in and speed this up, and the rear springs often go first. A faulty rear height sensor can also make the rear drop.
- What to do
- Don't drive far if the car is sitting on its bump stops or a 'Stop vehicle' message shows. Have the leaking strut found with a leak test and replaced quickly, because a leak makes the compressor overwork and fail too.
Active Body Control (ABC) hydraulic leak or pump failure
- What you'll notice
- An ABC warning message, a corner that drops quickly, a hard or bouncy ride, too much body lean, red hydraulic fluid under the car, or a howl from the engine bay at low revs. Applies to S600, AMG and other cars ordered with ABC.
- Why it happens
- The ABC system uses high-pressure hydraulic fluid instead of air. Its hoses and seals age, the pressure accumulators wear out after about 10 years or 60,000 miles, and neglected fluid wears the pump, valve blocks and struts.
- What to do
- Stop and check the fluid level if a red ABC warning appears; driving with a burst hose can run the pump dry. Have a specialist read the ABC fault log and check the fluid condition before replacing parts.
Hybrid inverter failure leaves car unable to start
- What you'll notice
- The car won't start at all and shows hybrid system warnings.
- Why it happens
- The inverter/converter that manages the hybrid system can fail. New parts are scarce and expensive.
- What to do
- Have the hybrid system scanned by a dealer or hybrid specialist. On a high-mileage car, compare the repair cost with the car's value before going ahead.
Air suspension compressor running constantly or burned out
- What you'll notice
- A loud humming from behind the front bumper that runs a long time, the car taking ages to lift, or the car staying down with a 'Vehicle too low' warning.
- Why it happens
- The compressor wears internally and can no longer build enough pressure. It usually fails early because a leaking air spring or valve block made it run far longer than it was designed to. A stuck relay can also keep it running until it burns out.
- What to do
- Find and fix any air leak before or at the same time as replacing the compressor, or the new one will fail too. Ask the shop to replace the compressor relay as well.
Crankshaft position sensor failure
- What you'll notice
- The engine stalls while driving, cranks but won't start (often when hot), or runs rough with a check engine light.
- Why it happens
- The crankshaft position sensor tells the engine computer when to fire. Heat breaks it down over time and it stops sending a signal.
- What to do
- Have the codes read. The sensor is inexpensive and a common cause of no-starts on these cars.
Water leaking into cabin or trunk
- What you'll notice
- Wet carpets, water in the trunk spare-tire well, a damp smell, fogged windows, or electrical faults after rain.
- Why it happens
- The sunroof drain tubes clog with debris and overflow, and taillight seals can let water into the trunk. Water then reaches modules and wiring.
- What to do
- Clear the sunroof drains and check the taillight seals. Dry the carpets quickly and have any wet modules checked before they corrode.
V12 misfire from ignition coils or spark plugs
- What you'll notice
- Rough idle, shaking, misfires and a flashing or steady check engine light.
- Why it happens
- The V12s have 24 spark plugs and coil packs that each fire six cylinders. These wear out, and the tight engine bay makes the work slow and costly.
- What to do
- Have the misfire codes read. Don't drive long with a flashing check engine light, as unburned fuel can damage the catalytic converters.
Climate blower motor stops working
- What you'll notice
- The fan works only some of the time, then stops completely, so there is no air from the vents for A/C or heat.
- Why it happens
- Moisture gets into the blower motor and it fails.
- What to do
- Have the blower motor tested. Replacement takes up to about two hours.
Power windows or door locks stop working
- What you'll notice
- A window won't go up or down, moves slowly, or a door won't lock or unlock with the key fob, most often the driver's door.
- Why it happens
- The heavy double-pane glass wears out window motors and regulators on older cars. Door control modules can corrode or fail internally, and lock actuators wear out.
- What to do
- Have the door panel removed and the regulator, motor, lock actuator or door module tested. Some door module repairs need a Mercedes-level scan tool to code the new part.
Repair prices for your 2011 Mercedes-Benz S-Class
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace one leaking Airmatic air strut
- Replace Airmatic compressor and relay
- Repair ABC leak (hose, accumulator or strut) or replace ABC pump
- Replace window regulator/motor or door lock actuator
- Replace crankshaft position sensor
- Clear sunroof drains and reseal taillights
- Replace V12 spark plugs and failed coil packs
- Replace blower motor
- Replace hybrid inverter/converter assembly
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…