Your 2009 Mercury Mountaineerproblems, repair costs and recalls
What we've documented about the 2009 Mercury Mountaineer: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2009 Mercury Mountaineer
15 documented issues apply to 2009, most serious first.
Transmission slips, surges or won't shift
- What you'll notice
- The engine surges or the truck jerks when pulling away or climbing hills, shifts are delayed or harsh, or it gets stuck in one gear.
- Why it happens
- Internal wear in the five-speed (V6) and six-speed (V8) automatics, sometimes helped early on by a computer reprogram but often ending in a rebuild.
- What to do
- Have the transmission codes and fluid checked and ask the dealer about any software updates. If it keeps slipping, get a transmission specialist to diagnose it before more damage is done.
Timing chain rattle on the 4.0L V6
- What you'll notice
- A rattle or buzzing from the engine for a few seconds after a cold start, or a constant rattle at idle. A check engine light for a misfire or cam timing code may follow.
- Why it happens
- The 4.0L SOHC V6 uses three timing chains with plastic guides and tensioners that wear out. The rear chain sits at the back of the engine, so the repair is very labor-heavy.
- What to do
- Do not ignore the rattle. Have a shop confirm which chain is noisy. If a chain or guide breaks, the engine can be badly damaged.
Worn ball joints
- What you'll notice
- Clunking over bumps, loose or wandering steering, or uneven tire wear on the front tires.
- Why it happens
- The front ball joints wear on these heavy SUVs and are among the most common repairs reported by owners.
- What to do
- Have the front end checked for play. A badly worn ball joint can separate and cause loss of control, so do not delay.
Radiator leaks at the plastic tank seams
- What you'll notice
- Coolant drips under the front of the truck, a sweet smell, the low-coolant level keeps dropping, or the temperature gauge climbs.
- Why it happens
- The radiator's plastic end tanks separate from the core at the seams. Many owners have replaced more than one radiator.
- What to do
- Top up with the correct coolant and watch the temperature gauge. Get the leak confirmed with a pressure test and replace the radiator before the engine overheats.
Cracked thermostat housing
- What you'll notice
- Coolant seeping or dripping near the top front of the engine, low coolant, or the engine running hot.
- Why it happens
- The plastic thermostat housing can crack with age and heat cycles.
- What to do
- Check the coolant level often and have the housing inspected for wetness or white crust. Replace the housing and thermostat together.
Wheel bearing or hub failure
- What you'll notice
- A humming or growling noise that gets louder with speed or when turning, play in the wheel, or an ABS light.
- Why it happens
- The wheel hubs and bearings are the most-reported repair on the Mountaineer in TrueDelta's survey, front and rear.
- What to do
- Have a shop check for play and noise at each wheel. Replace a worn hub soon, as a failing bearing can overheat or let the wheel wobble.
Spark plugs break during removal
- What you'll notice
- No symptoms while driving. The problem shows up at a tune-up when the shop warns that a plug broke off in the head, raising the bill.
- Why it happens
- The 3-valve 4.6L V8 uses a two-piece spark plug that can seize in the head and snap when removed.
- What to do
- Ask for a shop that uses the Ford removal procedure or a special extractor tool. Change the plugs on time; leaving them in longer makes them more likely to seize.
A/C stops blowing cold
- What you'll notice
- Warm or barely cool air from the vents, or the A/C compressor won't engage.
- Why it happens
- Slow refrigerant leaks and worn or seized compressors are common as these trucks age.
- What to do
- Have the system leak-tested before recharging. A seized compressor usually needs a new drier and a system flush too.
Misfire from a failed ignition coil
- What you'll notice
- Check engine light (sometimes flashing), rough idle, shaking or loss of power, especially when climbing hills.
- Why it happens
- Ignition coils fail with age and heat, often along with worn spark plugs.
- What to do
- Have the misfire code read. A flashing check engine light means stop driving hard to protect the catalytic converter.
Alternator stops charging
- What you'll notice
- Battery light on, dimming lights, a dead battery, or the truck dies while driving.
- Why it happens
- The alternator wears out, and it is one of the more common repairs in TrueDelta's survey.
- What to do
- Have the charging system tested before replacing the battery.
Clunking from worn sway bar links and bushings
- What you'll notice
- A rattle or clunk from the front over small bumps or rough roads.
- Why it happens
- The stabilizer (sway) bar end links and bushings wear and loosen.
- What to do
- Have the links checked. They are a low-cost fix, but replace them before they break.
Exhaust manifold leak ticking
- What you'll notice
- A ticking noise from the engine that is loudest when cold and fades as it warms up.
- Why it happens
- The exhaust manifold or its studs and gasket leak on the 4.6L V8.
- What to do
- Have the manifold area checked for black soot marks. Fix it soon so exhaust fumes don't reach the cabin.
Heat stuck on hot or clicking behind the dash
- What you'll notice
- The temperature won't change, heat blows when you want A/C, or you hear clicking behind the dash.
- Why it happens
- The blend door or its small electric actuator breaks, so the system can't mix hot and cold air.
- What to do
- Have the actuator tested. It is often reachable behind the dash or glovebox.
Blower fan stuck on high
- What you'll notice
- The fan runs at full speed no matter what setting you choose, or keeps running after the truck is off.
- Why it happens
- The blower motor control module (speed controller) fails.
- What to do
- Have the blower module replaced; it is usually behind the glovebox.
Squeal from the belt tensioner or idler pulley
- What you'll notice
- A squeal, chirp or grinding noise from the front of the engine, often worse at startup.
- Why it happens
- The serpentine belt tensioner and idler pulley bearings wear out.
- What to do
- Have the pulleys spun by hand to find the bad one. If it seizes, the belt can come off and you lose charging and steering assist.
Repair prices for your 2009 Mercury Mountaineer
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Rebuild or replace automatic transmission
- Replace timing chains, guides and tensioners
- Replace radiator and refill coolant
- Replace thermostat housing and thermostat
- Replace wheel hub and bearing assembly (one wheel)
- Replace front ball joints (one side)
- Replace sway bar end links and bushings
- Replace spark plugs with extraction of broken plugs
- Replace exhaust manifold gasket and studs (one side)
- Replace blend door actuator
- Replace blower motor control module
- Replace A/C compressor, drier and recharge
- Replace one ignition coil and spark plug
- Replace belt tensioner and idler pulley
- Replace alternator
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…