Your 2007 Porsche 911problems, repair costs and recalls
What we've documented about the 2007 Porsche 911: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2007 Porsche 911
13 documented issues apply to 2007, most serious first.
IMS bearing failure
- What you'll notice
- Often no warning at all. Some cars show metal flakes in the oil filter, an oil drip from the back of the engine, or a rattle or knock from the rear of the engine before it seizes.
- Why it happens
- The intermediate shaft (IMS) bearing on the regular Carrera engines is a sealed bearing that can lose its grease and wear out. When it fails, the cam timing is lost and debris goes through the engine. Single-row bearings fitted around 2002-2005 carry the highest risk. Turbo, GT2 and GT3 engines use a different design and are not affected.
- What to do
- Ask for records showing the bearing was upgraded. If not, many owners have an upgraded bearing fitted when the clutch is next replaced. Have the oil filter cut open and checked for metal at each service. If you hear a new knock, stop driving.
Cylinder bore scoring and oil burning
- What you'll notice
- Blue smoke, especially at start-up, rising oil use, a sooty tailpipe on one bank only, a ticking or tapping noise at idle, and sometimes misfire codes from oily spark plugs.
- Why it happens
- The cylinder walls in the 3.6 and 3.8 engines can get scratched (scored) by the pistons. Once scored, oil gets past the rings and is burned.
- What to do
- Have a specialist do a borescope (camera) inspection of the cylinders before buying or as soon as oil use goes up. A badly scored engine needs a rebuild with new cylinder liners, so get a firm diagnosis before spending money elsewhere.
Water pump failure and overheating
- What you'll notice
- Coolant drips or pink/crusty residue near the pump, a coolant smell, the temperature gauge rising, or a low-coolant warning.
- Why it happens
- The water pump has a plastic impeller and a seal that wear out. The impeller can crack and send bits into the cooling system, which can cause hot spots and even cracked cylinder heads.
- What to do
- If the temperature climbs, pull over and turn the engine off. Many specialists replace the pump about every 60,000 miles as prevention, along with the thermostat.
Cracked cylinder head or oil and coolant mixing
- What you'll notice
- Milky oil, oil in the coolant tank, white exhaust smoke, overheating, or coolant loss with no outside leak.
- Why it happens
- A cylinder head can crack from a hot spot, often after a water pump fails or debris blocks coolant passages. A failed oil cooler or a leaking seal can also mix oil and coolant.
- What to do
- Stop driving and have the oil and coolant checked. A specialist can rule out the cheaper cause (the oil cooler) before the engine is opened up.
Dropped intake valve seat
- What you'll notice
- Sudden loud ticking or knocking, misfire on one cylinder, and loss of power.
- Why it happens
- On the later 3.6 and 3.8 engines, an intake valve seat can come loose in the cylinder head. Broken pieces can damage the valve, piston and head.
- What to do
- Stop the engine right away if a new knock appears. A specialist will need to inspect the cylinder head.
Air-oil separator failure (smoke on start-up)
- What you'll notice
- Big clouds of white or blue smoke right after starting, oil smell, rough idle, high oil use, or a check engine light for lean running. The oil filler may be hard to remove because of strong suction.
- Why it happens
- The air-oil separator vents crankcase gases and returns oil to the sump. When its inner diaphragm tears or its hoses crack, oil is pulled into the intake and burned. Overfilling the oil makes it worse.
- What to do
- Check the oil level on level ground and do not overfill. If smoke and oil use continue, have the separator and its vent hoses checked; it is a fairly affordable part. Do not keep driving with heavy smoke, because a large gulp of oil can damage the engine.
Rear main seal oil leak
- What you'll notice
- Oil drips or a damp area where the engine meets the gearbox, under the middle-rear of the car.
- Why it happens
- The seal at the back of the crankshaft can leak, often because the crankcase seal bore was machined slightly off-center at the factory. Replacing the seal alone does not always stop the leak.
- What to do
- A small seep is not urgent but should be watched. The gearbox has to come out to replace it, so most owners do it together with a clutch or IMS bearing job.
Cracked coolant expansion tank
- What you'll notice
- Coolant level keeps dropping, a sweet smell, drips or residue under the engine lid, or a low-coolant warning light.
- Why it happens
- The plastic coolant expansion tank ages, and its seams or bleed valve crack and leak, so the system loses pressure.
- What to do
- Top up with the correct Porsche coolant and have the tank pressure-tested. Replace it before it leads to overheating.
Clogged or corroded front radiators and A/C condensers
- What you'll notice
- Engine running warmer than normal, weak air conditioning, coolant leaks at the front of the car, or leaves visible in the front bumper intakes.
- Why it happens
- The radiators and A/C condensers sit behind the front bumper openings. Leaves and dirt collect there, hold moisture and corrode the cores.
- What to do
- Have the bumper intakes cleaned out regularly. If a radiator or condenser is leaking, replace it before the engine overheats or the A/C gas escapes.
Misfire from cracked ignition coils
- What you'll notice
- Flashing or steady check engine light, rough running, shaking at idle, or loss of power.
- Why it happens
- The ignition coils sit on top of the spark plugs and crack from engine heat and water splash.
- What to do
- Have the misfire codes read. Coils are often replaced as a set with the spark plugs; PistonHeads says they typically need replacing every 50,000 miles.
Timing chain tensioner and guide wear
- What you'll notice
- A rattle at cold start that fades, or a cam-timing check engine light.
- Why it happens
- Tensioners weaken and the plastic tensioner pads can break, and chains stretch, especially with long oil-change intervals.
- What to do
- Have the cam timing (deviation) values checked with a scan tool. Replace worn tensioners before a chain can jump a tooth.
Manual gear shift cable breakage
- What you'll notice
- The gear lever goes loose or will not select some gears.
- Why it happens
- The cables connecting the manual gear lever to the gearbox can break.
- What to do
- Have the shift cables inspected. A car with a broken cable may be stuck in one gear, so arrange a tow if needed.
Front suspension creaks and worn bushings
- What you'll notice
- Creaking or clunking from the front over bumps, vague steering, or tires wearing on the inside edge.
- Why it happens
- Rubber bushings in the front control arms and the springs and shocks wear with age and mileage.
- What to do
- Have the suspension inspected and the alignment checked. Replacing worn parts together saves labor.
Repair prices for your 2007 Porsche 911
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace IMS bearing with upgraded kit (done with clutch and rear main seal)
- Engine rebuild with new cylinder liners and pistons
- Replace air-oil separator and vent hoses
- Replace rear main seal (gearbox removed)
- Replace water pump and thermostat, refill and bleed coolant
- Replace coolant expansion tank and cap
- Replace cylinder head (engine removed) or oil cooler
- Replace one front radiator or A/C condenser
- Replace ignition coil packs and spark plugs
- Replace timing chain tensioners and guide pads
- Cylinder head repair or engine rebuild
- Replace front control arm bushings or arms and align
- Replace manual shift cables
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…