Your 2003 Toyota 4Runnerproblems, repair costs and recalls
What we've documented about the 2003 Toyota 4Runner: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2003 Toyota 4Runner
6 documented issues apply to 2003, most serious first.
Frame rust in salt-belt states
- What you'll notice
- Flaking or bubbling rust on the frame rails and crossmembers, holes in the frame, or new creaks and clunks from underneath.
- Why it happens
- The frame's protective coating breaks down under road salt, and on many trucks the rust eventually eats through structural parts of the frame.
- What to do
- Have the frame inspected on a lift, especially before buying one of these trucks. A frame with holes is a safety risk and should be repaired or replaced before regular driving.
Fuel pulsation damper leak (recall 03V146)
- What you'll notice
- Raw fuel smell from the engine bay or wetness around the fuel rail.
- Why it happens
- The fuel pulsation damper on some early 2003 trucks may not have been put together correctly and can leak fuel near hot engine parts.
- What to do
- Any fuel smell means stop and get it checked. Confirm by VIN that the recall was done.
Free at a Toyota dealer under the recall. Check your VIN first.
Floor mat can trap the gas pedal (recall 11V113)
- What you'll notice
- The gas pedal sticks down or returns slowly, and the truck keeps accelerating.
- Why it happens
- An unsecured or wrong floor mat can slide forward and hold the accelerator pedal down. Toyota added these trucks to its floor mat recall.
- What to do
- Use only a secured mat made for this truck and never stack mats. Check the VIN for the recall. If the pedal sticks, shift to neutral and brake firmly.
Free at a Toyota dealer under the recall. Check your VIN first.
Head gasket failure on the early 4.0L V6
- What you'll notice
- A rough, shaky idle for the first minute after a cold start, a flashing or steady check engine light with a misfire on one cylinder, a sweet coolant smell from the exhaust, and a coolant level that keeps dropping with no puddle under the truck.
- Why it happens
- On early versions of the 4.0L V6 a head gasket can start to seep, usually at one of the rear cylinders, letting coolant into the cylinder while the engine sits. Owners most often report it well past the hundred-thousand-mile mark.
- What to do
- Do not keep driving with a cold-start misfire and falling coolant. Overheating or coolant in a cylinder can ruin the engine. Have a shop pressure-test the cooling system and check the cylinders before deciding on a repair.
Front brake calipers stick and drag
- What you'll notice
- The truck pulls to one side, a wheel gets very hot and smells after a drive, fuel economy drops, or the brake pedal feels like it stays slightly applied.
- Why it happens
- The front caliper slides and piston seize up, usually from corrosion in areas with road salt, so the pads stay pressed against the rotor.
- What to do
- Have the front brakes inspected. A dragging caliper cooks the pads and rotor and can overheat the wheel bearing, so do not put it off.
Cracked dashboard
- What you'll notice
- Long cracks across the top of the dash, sometimes near the passenger airbag area.
- Why it happens
- The soft dash pad breaks down from heat and sun over the years. Toyota issued a bulletin and extended coverage at the time, but that coverage is long over.
- What to do
- Not a driving hazard on its own. A dash cover or a replacement dash pad fixes the look.
Repair prices for your 2003 Toyota 4Runner
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Cut out rusted frame sections and weld in repair plates
- Replace head gaskets and resurface cylinder heads
- Replace front brake caliper, pads and rotor
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace fuel pulsation damperNo charge if your vehicle is included
- Modify or replace accelerator pedal and replace floor matNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…