Your 2013 Toyota 4Runnerproblems, repair costs and recalls
What we've documented about the 2013 Toyota 4Runner: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2013 Toyota 4Runner
5 documented issues apply to 2013, most serious first.
Hydraulic suspension leaks (KDSS or X-REAS)
- What you'll notice
- Oily fluid near the front sway bar or shocks, a suspension warning, a harsher ride, or the truck leaning to one side.
- Why it happens
- Trucks with KDSS or the X-REAS shock system use hydraulic lines and cylinders that can corrode or wear and start leaking with age.
- What to do
- Have the system inspected and the leak fixed. Rinse the underside after driving on salted roads to slow corrosion.
Front brake calipers stick and drag
- What you'll notice
- The truck pulls to one side, a wheel gets very hot and smells after a drive, fuel economy drops, or the brake pedal feels like it stays slightly applied.
- Why it happens
- The front caliper slides and piston seize up, usually from corrosion in areas with road salt, so the pads stay pressed against the rotor.
- What to do
- Have the front brakes inspected. A dragging caliper cooks the pads and rotor and can overheat the wheel bearing, so do not put it off.
Accessory exhaust tip can burn people behind the truck
- What you'll notice
- The chrome tip sits close to the bumper edge and stays very hot after driving.
- Why it happens
- A dealer-installed exhaust tip was fitted too far out, so someone loading the back can touch it.
- What to do
- Check the VIN for this recall. The fix is a smaller tip that sits recessed, and it is free.
Door lock actuator failures
- What you'll notice
- One or more doors will not lock or unlock with the key fob or switch, or the doors do not auto-lock.
- Why it happens
- The small motors inside the door latches wear out and stop working on many trucks of this era.
- What to do
- Have the failed actuator replaced. Lock that door by hand in the meantime.
Accessory hood scoop can come loose
- What you'll notice
- The add-on hood scoop lifts at the edges, rattles at speed, or peels away from the hood.
- Why it happens
- The scoop was held on with adhesive that can weaken with heat and washing.
- What to do
- Have the scoop mechanically fastened under recall 17V-425 so it cannot come off on the highway.
Repair prices for your 2013 Toyota 4Runner
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Replace leaking KDSS accumulator or cylinder
- Replace one door lock actuator
- Replace front brake caliper, pads and rotor
- Replace dealer-installed exhaust tip
- Mechanically fasten accessory hood scoop
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…