Your 2011 Toyota Tacomaproblems, repair costs and recalls
What we've documented about the 2011 Toyota Tacoma: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2011 Toyota Tacoma
6 documented issues apply to 2011, most serious first.
Rear leaf spring can break
- What you'll notice
- A bang or clunk from the rear, the truck sitting lower on one side, or a rear end that sags under load.
- Why it happens
- The rear leaf spring can crack and break. A broken piece can shift and puncture the fuel tank. Toyota recalled Pre-Runner and 4x4 trucks to inspect and replace the springs.
- What to do
- Check the VIN for recall 14V604. If the truck sits uneven or you smell fuel, do not haul or tow and get it inspected right away.
Free under recall 14V-604 for affected 2005-2011 trucks. Check your VIN with a Toyota dealer first.
Excess frame corrosion in salt states
- What you'll notice
- More rust on the frame than you would expect for the truck's age, flaking scale, or open rust holes.
- Why it happens
- Trucks driven in cold, salted states could corrode faster than normal. Toyota ran a limited service campaign to inspect frames, apply a rust-resistant coating and plugs, and replace the frame if the rust was already severe.
- What to do
- Ask a Toyota dealer whether your truck is covered by the frame corrosion campaign and have the frame inspected. Keep the underside rinsed in winter.
Driveshaft U-joint vibration
- What you'll notice
- Vibration through the floor or seat that rises with speed, or squeaking and clunking from under the truck.
- Why it happens
- The universal joints on the driveshaft can wear. Toyota set up a customer support program because a worn joint can damage the driveshaft if ignored.
- What to do
- Have the U-joints checked for play. Ask a Toyota dealer whether the support program still applies to your VIN.
Clunk or bump when starting or stopping
- What you'll notice
- A single clunk, or a feeling like being bumped from behind, as you pull away or come to a stop.
- Why it happens
- The sliding joint on the driveshaft gets dry and sticks, then releases with a jolt. Toyota issued bulletins for cleaning and greasing it on 2WD and 4WD trucks.
- What to do
- Ask a shop to clean and grease the driveshaft slip joint. It is annoying rather than dangerous.
Steering shaft rattle
- What you'll notice
- A rattle or clunk felt in the steering wheel on rough roads, sometimes with steering that feels a bit notchy.
- Why it happens
- The joint in the steering intermediate shaft wears and develops play. Toyota issued a bulletin for the rattle.
- What to do
- Have the intermediate steering shaft checked and replaced if it has play.
Headlight lens melting or bubbling
- What you'll notice
- Warped, bubbled or cracked plastic inside the headlight, a burnt plastic smell, or a dim beam.
- Why it happens
- Heat from the daytime running light bulb can distort the inner lens of the headlight. Toyota issued bulletins and an extended warranty for the headlights.
- What to do
- Inspect both headlights and replace damaged units. Ask a dealer whether the extended headlight warranty covers your truck.
Repair prices for your 2011 Toyota Tacoma
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Clean, treat and rustproof frame
- Clean and grease driveshaft slip joint
- Replace driveshaft U-joints
- Replace intermediate steering shaft
- Replace headlight assembly
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Replace both rear leaf spring assembliesNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…