Your 2014 Toyota Tacomaproblems, repair costs and recalls
What we've documented about the 2014 Toyota Tacoma: problems owners and shops report, typical repair and upkeep costs, and safety recalls.
Pick your engine to hide problems that only affect other engines. Not sure? It is on the sticker under the hood or in the owner's manual.
Ownership snapshot
Averages, not quotesRoutine maintenance costs (model-wide, not specific to one year or engine)
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
Ask for an estimate
The problems here are the ones we've documented so far, not a complete list or a reliability rating. Ask your shop for a written total that covers the work on your engine and trim, including any diagnostic fees, taxes and shop supplies.
Known problems for your 2014 Toyota Tacoma
4 documented issues apply to 2014, most serious first.
Valve springs can break and stall the engine (recall)
- What you'll notice
- A tick or misfire, rough running, then the engine cutting out while driving.
- Why it happens
- Some valve springs were made out of spec and can break, which stops the valve working properly.
- What to do
- Check your VIN for this recall and have it done. A stall in traffic is a real risk.
Free under recall 13V-557: dealers replace the valve springs. Check your VIN with a Toyota dealer first.
Excess frame corrosion in salt states
- What you'll notice
- More rust on the frame than you would expect for the truck's age, flaking scale, or open rust holes.
- Why it happens
- Trucks driven in cold, salted states could corrode faster than normal. Toyota ran a limited service campaign to inspect frames, apply a rust-resistant coating and plugs, and replace the frame if the rust was already severe.
- What to do
- Ask a Toyota dealer whether your truck is covered by the frame corrosion campaign and have the frame inspected. Keep the underside rinsed in winter.
Secondary air injection pump failure
- What you'll notice
- Check engine light with codes P2440 or P2442, sometimes the truck going into reduced power for a short time after a cold start.
- Why it happens
- Moisture gets into the air injection pump and its valve, which then stick or fail. Toyota issued a bulletin and extended coverage on the system.
- What to do
- Have the codes read and ask a Toyota dealer whether your truck has extended coverage for the air injection system.
Clunk or bump when starting or stopping
- What you'll notice
- A single clunk, or a feeling like being bumped from behind, as you pull away or come to a stop.
- Why it happens
- The sliding joint on the driveshaft gets dry and sticks, then releases with a jolt. Toyota issued bulletins for cleaning and greasing it on 2WD and 4WD trucks.
- What to do
- Ask a shop to clean and grease the driveshaft slip joint. It is annoying rather than dangerous.
Repair prices for your 2014 Toyota Tacoma
Insufficient verified pricing for this vehicle and repair. We have not yet matched these repairs to two independent, dated price sources for this vehicle, so we show no price, chart or verdict for them.
- Clean, treat and rustproof frame
- Clean and grease driveshaft slip joint
- Replace secondary air pump and switching valve
Recall repairs: usually free at the dealer
A dealer can confirm coverage by VIN. An eligible safety recall repair is provided at no charge.
- Inspect and replace valve springsNo charge if your vehicle is included
Disclaimer: Estimates only, not a quote. Ranges are averages built from typical parts prices plus standard book labor time at a typical shop labor rate. Your price will depend on your area, the shop, the parts used and what the shop finds. Dealers often charge more. Diagnosis and taxes are extra.
Checking the NHTSA recall database…